Sharif Digital Repository

The purpose of this study is to determine the influence of nano-alumina particles on the self-flow characteristics of aluminaspinel self-flowing castables. for this reason, the self-flow characteristics such as; self-flow value and working time of the alumina-spinel castables with different amount of nano-alumina particles have been studied. Also, the mechanical properties and microstructure of these castables have been studied. for the study of nano-alumina (d50 =4 3 nm) addition on selfflow characteristics and other properties of these castables, reactive alumina is substituted by nano-alumina powder in 0-4 wt.% range. The results show that the nano-alumina particles have great effect on... 

Lumped method (Electrical analogy) is a quick and easy way to model human cardiovascular system. In this paper Lumped method is used for simulating a complete model. It describes a 36-vessel model and cardiac system of human body with details that could show hydrodynamic parameters of cardiovascular system. Also this paper includes modeling of pulmonary, atrium, left and right ventricles with their equivalent circuits. Exact modeling of right and left ventricles pressure with division of ascending aorta into 27 segments increases the accuracy of our simulation. In this paper we show that a calculated pressure for aorta from our complex circuit is near to measured pressure by using advanced... 

In the past two decades, microfluidic systems have become more appealing due to their wide applications in many areas, such as electronics, biotechnology, medicine, etc. Recently, the advantages of using the bubble growth phenomenon as a robust actuator in microfluidic devices have directed research interests towards the investigation of various applications. In this research, a new transient thermo-hydraulic model has been developed for bubble growth in confined volumes. The present model has been used to describe the pumping effect produced by the bubble growth and collapse phenomenon in microchannels. The results show relatively good agreement with experimental data. This study is useful... 

The thermal behavior of Fe3Si2O5(OH)4·Sb3O6(OH)·Sb2O3 (a sample of antimony from Sefidabe mine in Zahedan) was investigated by the technique of thermogravimetry under air atmosphere from 25 to 1200 °C. The obtained results from TGA were reported. This study reports comprehensive information about these minerals. XRD and XRF techniques, UV/visible and elemental analysis such as ICP are used to identify the products at different decomposition steps. The acidic leaching of this mineral Fe3Si2O5(OH)4·Sb3O6(OH)·Sb2O3 is carried out, and the obtained results are reported. In total, the recovery was achieved by leaching with hydrochloric acid was 85% at D80 granulation below 45 microns. In leaching... 

Using two techniques of thermogravimetry and differential scanning calorimetry under O2 and N2 gas atmosphere from 25 to 600 °C, the thermal behavior of chromium(VI) oxide CrO3 was investigated. The identity of products at different decomposition steps was confirmed by XRD technique. Both techniques produced similar results supporting the same steps for the compound. The received products were investigated by SEM electron microscope. The form and the size of crystals were investigated. Three distinct energy changes were observed, namely, two endothermic and one exothermic in DSC. The amount of ΔH for each peak is also reported  

Site visits of selected factories and mines show large amounts of coal were collected as spoil and waste outside these locations due to un-efficiency of coal exploiting technology from mined material. The coal content of these waste materials is about 60%. In this work, we propose a method to be used for complete consumption of these materials in industry. In some samples, volume and weight of spoils could be decreased by half. This review also shows that aluminum oxide in industrial and minerals spoils are high, in some samples up to 25%. We suggest some remedies, e.g. we can use ashes produced by complete combustion of coal for production of aluminum hydroxide thus making it economical.... 

During the recent decade, high induction diffusers have become more appealing in applications which require relatively high ventilation airflow rates, such as clean rooms. In this research, the effect of geometric parameters on the performance of a specific type of swirling air diffuser is investigated numerically. The results show that although the diffuser slots geometry, namely their angle and aspect ratio, is impressive on the diffuser performance, it is not as important as the swirling blade angle and the performance is almost constant in a wide range of slots specifications. The results also demonstrate that the diffuser performance and the resultant indoor airflow distribution highly... 

Surgical site infection (SSI) is one of the important infectious problems in hospitals. It is well known that appropriate ventilation strategy is most effective way to control bacteria-carrying airborne particles responsible for SSI. With considerable improvement in the computational capacity of computers, computational fluid dynamics (CFD) technique has been widely used to study the indoor airflow and contaminant dispersion over the enclosures. In this research, the effect of inlet air velocity on the ultra-clean ventilation system performance is investigated Eulerian-Lagrangian numerical approach. The results show that surgical wound contamination may be highly affected by inlet velocity.... 

Increasing concerns about global warming and environmental pollution control has pushed the relevant organizations to set regulations and to develop programs for energy saving. In addition, for many high energy using appliances, energy labeling provides the end user with important data to select energy-efficient equipments and encourage the manufacturers to enhance the performance of their productions. In this research, a new energy-saving program for wet cooling towers has been developed. Considering a thermo-hydraulic analysis, a novel Energy Index (IE) has been extracted which takes all aspects of the problem into account. The present index can be used as a proper criterion for energy... 

Social norms are a core concept in social sciences and play a critical role in regulating a society's behavior. Organizations and even governmental bodies use this social component to tackle varying challenges in the society, as it is a less costly alternative to establishing new laws and regulations. Social networks are an important and effective infrastructure in which social norms can evolve. Therefore, there is a need for theoretical models for studying the spread of social norms in social networks. In this paper, by using the intrinsic properties of norms, we redefine and tune the Rescorla-Wagner conditioning model in order to obtain an effective model for the spread of social norms. We... 

The primary source of surgical site infection is the deposition of flakes released from the exposed skin of surgical staff or the patient on the exposed surgical wound. In this study, a computational model for simulating air ow and thermal conditions in an operating room is developed, and transport and deposition of particulate contaminants near the wound are analyzed. The results show the formation of a thermal plume over the wound tissue, which is typically at a higher temperature than the surrounding. The thermal plume protects the wound from the deposition of contaminants. In addition, the computational model predicts an optimum value for the inlet air velocity that is mainly maintaining... 

Nowadays, as the oil reservoirs reaching their half-life, using enhanced oil recovery methods is more necessary and more common. Simulations are the synthetic process of real systems. In this study, simulation of water and surfactant injection into a porous media containing oil (two-phase) was performed using the computational fluid dynamics method on the image of a real micro-model. Also, the selected anionic surfactant is sodium dodecyl sulfate, which is more effective in sand reservoirs. The effect of using surfactant depends on its concentration. This dependence on concentration in using injection compounds is referred to as critical micelle concentration (CMC). In this study, an... 

This study explored thermal behavior of four kinds of chromium compounds such as CrO3, K2Cr2O7, K2CrO4, and Cr2O3 using thermogravimetry (TG) and differential scanning calorimetry (DSC) method under the oxygen (O2) and nitrogen (N2) gas atmosphere at varying temperatures (25 to 1600 ℃). A diverse of chromium compounds were carefully evaluated for the first time through this method, and the present work provides new, comprehensive and valuable information regarding the mentioned compounds. XRD technique and elemental analysis were applied in order to recognize the products at diverse decomposition stages. The obtained products were then investigated via a SEM electron microscope. Also, the... 

Background The cornea plays a role in the refractive power of the eye, and when its natural curvature and thickness are compromised by diseases such as keratoconus or high myopia, this results in loss of visual acuity. Intracorneal rings (ICRs) were developed as a treatment option to restore the natural corneal curvature by implanting rings into tunnels cut within the corneal stroma. However, selecting and placing the appropriate ring can be difficult, and predicting refractive outcomes is challenging. Objective The purpose of this study was to better understand the design parameters of the rings that determine postoperative refractive and mechanical outcomes. Methods We developed an... 

Herbal medicine wastes (HMWs) are byproducts of medicine factories, which are mainly landfilled for their environmental problems. Only bearing in mind the contamination and concerns caused by the COVID-19 pandemic and environmental emissions, the worth of herbal medicine wastes management and conversion to green products can be understood. In this work, subcritical water treatment was carried out batch-wise in a stainless tube reactor in the pressure range of 0.792–30.0 MPa, varying the temperature (127–327 °C) and time (1–60 min) of extraction. This resulted in new and green material sources, including organic acids, amino acids, and sugars. Amazingly, at very low extraction times (below 5... 

The acidity and stability constants of M (MNPPAP) (MNPPAP: 2((4-methyl-5-nitro-6-(pyrrolidine-l-yl)pyrimidine-2-yl)amino)propionic acid) M: Cu2+, Cu (Bpy)2+ (Bpy: 2,2'-Bipyridine), or Cu(Phen) (Phen: 1,10-Phenanthroline) complexes were determined by potentiometric pH titration. It is shown that the stability of the binary Cu (MNPPAP) complex is determined by the basicity of the carboxylate group on one side and amine group on the other side. It is demonstrated that the equilibrium, Cu(Har)2+ (H ar: Heteroaromatic ligand such as Bpy or Phen) + Cu(MNPPAP) ^ Cu(Har)(MNPPAP) + Cu2+, is displacement due to the well known experience that mixed ligand complexes formed by a divalent 3d ion, a... 

The goal of this work is separation and recovery of catalyst residue in wastewater and byproducts of PTA (poly terephetalic acid) unit. Catalyst recovery consists in separating the maximum amount of catalyst and changing the same into valuable compounds. The PTA unit uses cobalt catalyst for oxidation reactions. The byproducts, which contain catalyst, were burned. In the case of metal oxide recovery in the ashes of waste materials, we could solve the problem of the Petrochemical Company. This new method may help us to recover catalyst from wastewater in PTA unit, after which small amounts of ions may be absorbed on a column filled with special absorbent, in such a way that the wastewater... 

Despite complex fluctuations, missing data, and maintenance costs of detectors, traffic volume forecasting at intersections is still a challenge. Moreover, most existing forecasting methods consider an isolated intersection instead of multiple adjacent ones. By accurately forecasting the volume of short-term traffic, a low-cost method can be provided to solve the problems of congestion, delay, and breakdown of detectors in the road transport system. This paper outlines a novel hybrid method based on deep learning to estimate short-term traffic volume at three adjacent intersections. The gated recurrent unit (GRU) and long short-term memory (LSTM) bilayer network with wavelet transform (WL)... 

The compounds α-lead oxide (α-PbO) and β-lead oxide (β-PbO) were purchased from Merck co. and used for thermal investigations in laboratory. The compound was heated in a thermogravimeter at different temperature, from 25 to 400 °C. The used gas atmosphere was O2. The received products were investigated by X-ray diffraction (XRD) technique. The received product Pb3O4 was confirmed by XRD. The textures of two different morphologies of α-PbO, β-PbO and the product Pb3O4 is investigated by scanning electron microscope (SEM) and transmission electron microscope (TEM) techniques. © 2018, Faculty of Metallurgy. All rights reserved  

With regards to the global continuous growth in consumption of base metals such as antimony (Sb), mining companies are currently looking to improve the productivity and extraction of Sb from low grade ore in order to economically process it. With this aim, in this study, an efficient protocol was developed to recover metallic Sb from the low grade Fe3Si2O5(OH)4. Sb3O6(OH). Sb2O3 ore of the Sefid-Abe mine in Zahedan province, Iran, utilizing selective acidic or alkaline leaching followed by Sb electrowinning. A process was developed to recover antimony from an Sb2O3 ore source, using selective acidic or alkaline leaching followed by antimony electrowinning. Sb could be leached with an...