Sharif Digital Repository

The travel time of subsurface flow in complex hillslopes (hillslopes with different plan shape and profile curvature) is an important parameter in predicting the subsurface flow in catchments. This time depends on the hillslopes geometry (plan shape and profile curvature), soil properties and climate conditions. The saturation capacity of hillslopes affect the travel time of subsurface flow. The saturation capacity, and subsurface travel time of compound hillslopes depend on parameters such as soil depth, porosity, soil hydraulic conductivity, plan shape (convergent, parallel or divergent), hillslope length, profile curvature (concave, straight or convex) and recharge rate to the groundwater... 

In this work, the mesoporous magnetic heterogeneous catalyst was synthesized by anchoring copper (II) onto the nitrogen-rich poly (melamine) Schiff base networks magnetic nanocomposite. First, MNP (Fe3O4@SiO2) was functionalized with chlorosilane (CPTS). Then, the chlorine of these functionalized magnetic nanoparticles could react with the –NH2 groups of the melamine through a nucleophilic substitution reaction. Simultaneously, the condensation polymerization of melamine and benzene-1, 3, 5-tricarbaldehyde was carried out in the presence of surface-modified magnetic nanoparticles. Later, Fourier-transform infrared spectroscopy (FT-IR), X-ray diffraction (XRD), thermogravimetric analysis... 

Time of concentration (TC) of surface flow in watersheds depends on the coupled response of hillslopes and stream networks. The important point in this background is to study the effects of the geometry and the shape of complex hillslopes on the time of concentration considering the degree of flow convergence (convergent, parallel or divergent) as well as the profile curvature (concave, straight or convex). In this research, the shape factor of complex hillslopes as introduced by Agnese et al. (2007) is generalized and linked to the TC. A new model for calculating TC of complex hillslopes is presented, which depends on the plan shape, the type and degree of profile curvature, the Manning... 

The simultaneous control of the molecular weight, separation, and purification of polyvinyl acetate was achieved using a cobalt-mediated radical polymerization (CMRP) in a packed column with silica gel particles (PC-CMRP). The controlled radical polymerization of VAc in the packed columns was evaluated from the linear time dependence of Ln[M]0/[M], linear increase of molecular weight with the increase in conversion, and narrow molecular weight distribution. PC-CMRP method was used to produce high-purity polymers with controlled molecular weight and narrow molecular weight distribution without requiring additional purification steps. The high ability of silica gel particles to adsorb free... 

In recent years there has been potential increase in the use of alkaline protease as industrial catalysts. Many major industrial and commercial applications, such as food and textile industries, and medical diagnoses, are highly dependent on the protease enzyme. In the cell immobilization technique, the free movement of microorganisms is restricted in the process, and a continuous system of fermentation can be used. In the present work, this technique has been used for alkaline protease production using different carriers, such as chitosan, corn cob and corn tassel. Enzyme activity before immobilization (72 h) was 78.3 U/ml. Corn cob, with 65% immobilization capacity and the highest enzyme... 

In the present study, we aimed to quantify the effects of COVID-19 restrictions and speech treatment approaches during lockdowns on autistic children using CBCL and neuro-fuzzy artificial intelligence method. In this regard, a survey including CBCL questionnaire is prepared using online forms. In total, 87 children with diagnosed Autism spectrum disorders (ASD) participated in the survey. The influences of three treatment approaches of in-person, telehealth and public services along with no-treatment condition during lockdown were the main factors of the investigation. The main output factors were internalized and externalized problems in general and their eight subcategory syndromes. We... 

The microstructure evaluation and phase transformation of multi-pass friction stir-processed (FSP) commercially pure titanium were investigated using optical microscopy, scanning electron microscopy equipped with a backscatter detector, and electron backscatter diffractometer. The microstructure characterization shows that the grain refinement mechanism changed with the increasing number of passes. The equiaxed α grains in the untreated sample changed to lath-shaped grains surrounded by serrated grain boundaries, and produced Widmanstätten morphology during the cooling cycle of FSP. The higher micro-hardness values and bio-corrosion resistances of the FSP-treated samples are due to their... 

Estate administration involves managing and distributing a deceased individual’s assets to beneficiaries, as well as managing the liabilities. This process comprises legal, financial, and administrative tasks that ensure assets are transferred based on the deceased's wishes and in accordance with the law. In Southeast Asia countries such as Indonesia, Malaysia and Brunei where Muslims represents the majority of population, the Islamic law plays an integral part in the inheritance management as the process to be in line with the Islamic teachings and principle. The role of the syariah authority namely the syariah courts is prevalent and therefore, abidance to the rule under the syariah legal... 

A novel intelligent semi-active control system for an eleven degrees of freedom passenger car's suspension system using magnetorheological (MR) damper with neuro-fuzzy (NF) control strategy to enhance desired suspension performance is proposed. In comparison with earlier studies, an improvement in problem modeling is made. The proposed method consists of two parts: a fuzzy control strategy to establish an efficient controller to improve ride comfort and road handling (RCH) and an inverse mapping model to estimate the force needed for a semi-active damper. The fuzzy logic rules are extracted based on Sugeno inference engine. The inverse mapping model is based on an artificial neural network... 

Using CNG as an additive for gasoline is a proper choice due to higher octane number of CNG enriched gasoline with respect to that of gasoline. As a result, it is possible to use gasoline with lower octane number in the engine. This would also mean the increase of compression ratio in SI engines resulting in higher performance and lower gasoline consumption. Over the years, the use of simulation codes to model the thermodynamic cycle of an internal combustion engine have developed tools for more efficient engine designs and fuel combustion. In this study, a thermodynamic cycle simulation of a conventional four-stroke spark-ignition engine has been developed. The model is used to study the... 

With the declining energy resources and increase of pollutant emissions, a great deal of efforts has been focused on the development of alternatives for fossil fuels. One of the promising alternative fuels to gasoline in the internal combustion engine is natural gas [1-5]. The application of natural gas in current internal combustion engines is realistic due to its many benefits. The higher thermal efficiency due to the higher octane value and lower exhaust emissions including CO2 as a result of the lower carbon to hydrogen ratio of the fuel are the two important feature of using CNG as an alternative fuel. It is well known that computer simulation codes are valuable economically as a cost... 

Gaining insight into possible vibratory responses of dynamical systems around their stable equilibria is an essential step, which must be taken before their design and application. The results of such a study can significantly help prevent instability in closed-loop stabilized systems by avoiding the excitation of the system in the neighborhood of its resonance. This paper investigates nonlinear oscillations of a rotary inverted pendulum (RIP) with a full-state feedback controller. Lagrange’s equations are employed to derive an accurate 2-DoF mathematical model, whose parameter values are extracted by both the measurement and 3D modeling of the real system components. Although the governing... 

A suction-controlled ring device has been developed to continuously measure the coefficient of lateral soil pressure in deformable unsaturated soil samples from the at-rest to the active condition under application of increasing vertical pressure and controlled matric suction. The device incorporates a thin aluminum specimen ring equipped with horizontal strain gages for recording the lateral soil strains. In addition, a sensor recording water volume changes is utilized to continuously monitor the degree of saturation of the soil sample during tests. The matric suction within the soil texture is controlled using the axis translation technique. In order to verify the performance of the ring... 

We introduce a new smooth, non-toxic, biocompatible method for cross-linking of gum tragacanth (GT), a polysaccharide of natural origin, in order to serve as a new supporting matrix for immobilization systems. The modified gum is used as a matrix for the catalysis of the conversion of benzyl penicillin to 6-aminopenicillanic acid (6-APA) by means of Escherichia coli ATCC11105 with penicillin G acylase (PGA) activity. The results show that GT beads can not only serve as a proper matrix for immobilization, but show enhanced hydrolysis rate and stability compared to other immobilization systems used for this reaction. This signifies the potential of GT as a biocompatible matrix for... 

The Class-E power amplifier has been widely studied and formulated in the literature. Although the majority of reported inductive coupling wireless power transfer (WPT) systems use a class-E power amplifier for driving the primary coil, still there is a lack of a comprehensive study on class-E circuit dedicated to WPT, providing a set of closed form design equations for proper class-E operation. This paper presents the required design equations needed to design a 'true' class-E circuit for WPT applications. Equations for the series-tuned secondary coil WPT system are presented, as well as two different design procedures for the parallel-tuned secondary coil. The derived equations have been... 

Pole Side Impact Tes is one out of three crash tests described by Euro NCAP standard for star rating of a vehicle and is required for assessing the Adult Occupant Protection. In this paper the goal is to determine the crashworthiness of side doors and B pillar in a Pole Side Impact Test based on Euro New Car Assessment Program (Euro-NCAP) using computer and simulation method. In this matter, a vehicle model has been prepared and meshed using Hypermesh and CATIA. The velocity of 29 km/h has been assigned to the vehicle which was on top of a cart while the pole has been assigned as a rigid static object based on Euro NCAP requirements specifically. Results show that different amounts of energy...