Sharif Digital Repository

Generation scheduling is a crucial challenge in power systems especially under new environment of liberalization of electricity industry. This paper is focused on the economical aspect of UC problem, while the next load demand as a very important issue and prohibited operation zones and spinning reserve uncertainty as practical constraints have been taken in to account. The impacts of hot/cold start-up cost have been considered in this paper. Numerical results show a significant improvement in the solutions of a cost-based unit commitment in comparison with the other studies. © 2009 Praise Worthy Prize S.r.l  

The aim of this study is to show the effectiveness of prohibited operating zone. Generation scheduling is a crucial challenge in power systems especially under new environment of liberalization of electricity industry. This study is focused on the economical aspect of unit commitment problem. Since, the generating units may have certain ranges where operation is restricted based upon physical limitations of machine components or instability. Therefore, Prohibited Operating Zones (POZ) as a redundant constraint is considered, while the next load demand as a very important issue is deliberated. In this study generation scheduling of each hour is conducted by considering the next load demands... 

In recent years, due to the goal of decarbonizing energy systems, Renewable Energy Sources (RESs) have attracted attention as the primary potential energy resource in many countries. Thus, the utility-scale deployment of these resources has become of utmost importance. The large-scale connections and the intermittent as well as variable characteristics of these RESs cause challenges in maintaining a balance between power generation and consumption. Furthermore, supplying base load using RESs is another challenge for system operators. Hybrid RESs (HRESs), including solar and wind, together with energy storage, might be a remedy via which the resources can complement each other to some extent.... 

This paper presents an incentive-based demand response (DR) scheme for a small residential area including several houses. It is supposed that there is an aggregator on one side and the residential consumers on the other side, which both of them want to achieve an optimal solution for themselves. For this reason, the Stackelberg game is adopted in this paper to consider the interaction between aggregator and consumers. This game would have one leader (aggregator) and N followers (consumers). Each consumer is assumed to have two kinds of load, namelycritical load, which is not intended for DR, and Heating, ventilation, and air conditioning (HVAC) system, which is considered as a potential for... 

Wind power producers have recently gained a significant penetration in the electric power network, which might cause some challenges for the system operation due to the uncertainties in the generated power. In this way, wind power owners may offer different services, such as providing reserve capacity besides their conventional role of delivering just energy. Currently, conventional generators are the main responsible for providing some reserve in case of uncertainty in renewable generation and demand changes. Therefore, this article introduces a novel approach that allows wind power producers to participate in both energy and reserve markets alongside conventional generators. A two-stage... 

This paper proposes a solver-friendly model for disjoint, non-smooth, and nonconvex optimal power flow (OPF) problems. The conventional OPF problem is considered as a nonconvex and highly nonlinear problem for which finding a high-quality solution is a big challenge. However, considering practical logic-based constraints, namely multiple-fuel options (MFOs) and prohibited operating zones (POZs), jointly with the non-smooth terms such as valve point effect (VPE) results in even more difficulties in finding a near-optimal solution. In complex problems, the nonlinearity itself is not a big issue in finding the optimal solution, but the nonconvexity does matter and considering MFO, POZ, and VPE... 

This paper proposes an indirect load control demand response (DR) strategy for residential houses. A Stackelberg game theory is applied to account for the interaction between the aggregator in one side and the consumers on the other side. The aggregator, which owns a wind power plant, strives to maximize wind power utilization by consumers. Therefore, it motivates the consumers to adjust their load demand according to the forecasted wind power production by offering a bonus to them. On the other hand, consumers attempt to achieve the highest amount of reward by changing their load profile. It is assumed that each consumer has a critical load of which they have no control, and also a flexible... 

Efficient utilization of renewable generation inside microgrids remains challenging. In most existing studies, the goal is to optimize the energy cost of microgrids by working in synergy with the main grid. This work aimed at maximizing the self-consumption of on-site photovoltaic (PV) generation using an electrical storage, as well as demand response solutions, in a building that was also capable of interacting with the main grid. Ten-minute resolution data were used to capture the temporal behavior of the weather. Extensive mathematical models were employed to estimate the demand for hot-water consumption, space cooling, and heating loads. The proposed framework is cast as mixed-integer... 

Using multiple antennas at the transmit and receive sides of a passive radar brings both the benefits of MIMO radar and passive radar. However one of the obstacles arisen in such configuration is the receive antennas placement in proper positions so that the radar performance is improved. Here we just consider the case of positioning one receiver among multiple illuminators of opportunity. Indeed it is a start for the solution of optimizing the geometry of the multiple receivers in a passive radar  

SbCl3 supported on montmorillonite K-10 is an efficient catalyst for the ring opening of epoxides with aromatic amines under solvent-free conditions and microwave irradiation to give the corresponding b-amino alcohols in high yields with high regioselectivity  

In this paper, we consider an integrated sensing and communication (ISAC) system with wireless power transfer (WPT) where an unmanned aerial vehicle (UAV)-based radar serves a group of energy-limited communication users in addition to its sensing functionality. In this architecture, the radar senses the environment in phase 1 (namely sensing phase) and mean-while, the communications users (nodes) harvest and store the energy from the radar transmit signal. The stored energy is then used for information transmission from the nodes to UAV in phase 2, i.e., uplink phase. Performance of the radar system depends on the transmit signal as well as the receive filter; the energy of the transmit... 

One of the important obstacles in MIMO (Multiple Input Multiple Output) radars is the issue of designing proper transmit signals. Indeed, the capability of signal design is a significant advantage in MIMO radars, through which, the system can achieve much better performance. Many different aspects of this performance improvement have been considered yet, and the transmit signals have been designed to attain such goal, e.g., getting higher SNR or better detector's performance at the receiver. However, an important tool for evaluating the radar's performance is its ambiguity function. In this paper, we consider the problem of transmit signal design, in order to optimize the ambiguity function... 

Two gains play key roles in recently developed MIMO wireless communication systems: "spatial diversity" gain and "spatial multiplexing" gain. The diversity gain refers to the capability to decrease the error rate of the MIMO channel, while the multiplexing gain implicitly refers to the amount of increase in the capacity of the MIMO channel. It has been shown that there is a fundamental tradeoff between these two types of gains, meaning interplay between increasing reliability (via an increase in the diversity gain) and increasing data rate (via an increase in the multiplexing gain). On the other hand, recently, MIMO radars have attracted much attention for their superior ability to enhance... 

It is a well known fact that using multiple antennas at transmit and receive sides improves the detection performance. However, in such multiple-input multiple-output (MIMO) configuration, proper positioning of transmitters and receivers is a big challenge that can have significant influence on the performance of the overall system. In addition, determining the power of each transmitter under a total power constraint is a problem that should be solved in order to enhance the performance and coverage of such a system. In this paper, we design the Neyman-Pearson detector under the Rayleigh scatter model and use it to introduce a criterion for the antenna placement at both transmit and receive... 

There has been much interest, recently, towards exploiting the Multiple-Input Multiple-Output (MIMO) technique in radar. It is shown that using multiple antennas at transmit and receive sides can improve the performance of the system. However, in order to analyze the system's performance, its ambiguity function, i.e. the ambiguity function of a MIMO radar, is needed to be defined. In this paper, beginning from the information theoretic definitions, we derive such function, specifically for a MIMO radar with widely separated antennas  

By combining the two ideas of MIMO (Multiple Input Multiple Output) and PCL (Passive Coherent Location) in radar, one can achieve the advantages of both recently developed techniques simultaneously. While using multiple antennas at the receive side provides a spatial diversity of the object to be detected, using multiple illuminators of opportunity, most importantly, makes the radar covert to the interceptors. One obstacle in such MIMO configuration is choosing the positions of the receive antennas. In this paper, after analyzing the Neyman-Pearson detector for the DVB-T based PCL, we introduce the probability of missed detection as a criterion to place the receive antenna. Here, we only... 

One of the most important obstacles in passive radar applications is removing the direct signal from the target channel. Otherwise, week echoes from the targets in the target channel would be ignored due to the limited dynamic range of the system. One of the most effective techniques in this field is using adaptive filters. In this paper various adaptive filters are introduced and their performances are shown and compared  

It has been shown that using multiple antennas in a radar system improves the performance considerably, since multiple target echoes are received from different aspect angles of the target. In this way, the target detection is improved. However, when using multiple antennas, some problems, such as designing the transmit signals, synchronization, etc. emerge that should be solved. One of such problems is the receiver placement. Receiver placement deals with choosing a proper position for the receive antenna in order to optimize the whole system's performance. In this paper, a receiver placement procedure based on improving the radar ambiguity function is proposed for the case of a multisite... 

By employing the MIMO (multiple-input-multiple-output) technology in radar, some new problems emerged, that, in order to benefit the MIMO gains in radar, it was necessary to solve them suitably. One of such obstacles is determining the positions of receive antennas in a MIMO radar system with widely separated antennas (WS MIMO radar), since it is shown that the antennas' positions affect the whole system's performance considerably. In this study, a proper receivers' positioning procedure is proposed. To do this end, four criteria are developed based on the proposed MIMO detector and the MIMO ambiguity function. The simulations verify that the proposed positioning procedure improves the...