Sharif Digital Repository

Using an appropriate design of electrodes and adjustment of the thyratron decoupling circuit as a high-repetition-rate and high-voltage switch, very stable operation of a copper vapor laser at high pressures was obtained. This was achieved by canceling the intense filamentation in the laser plasma at the higher pressures. The transverse grooves on the inner surface of the funnel-shaped copper electrodes permit operation of the laser up to 100 torr. This design reduces the cathode-fall voltage, and as a result reduces the thermal loading in the cathode-fall region. The optimum pressure was 80 torr. At this condition the output power was more than that observed with expensive molybdenum... 

The influence of liquid bulk viscosity on the dynamics of a single cavitation bubble is numerically studied via Gilmore model with a new modified boundary condition at bubble interface. In order to more accurately describe the interior gas thermodynamics, a hydrochemical model is used. The numerical results for an argon bubble in water and aqueous H2SO4 show that including the liquid bulk viscosity slightly affects the bubble dynamics in collapse phase. This effect becomes significant only at high ultrasonic amplitudes and high viscosities. Moreover, the maximum pressure value inside the bubble is much more influenced than the maximum temperature. This finding lends support to results of... 

The main effects of liquid compressibility on the dynamics of single bubble sonoluminescence are investigated via three different radial dynamics models. In order to precise description of the interior gas thermodynamics, a hydrochemical model is used. In the case of an argon gas bubble in water, the results obtained with the Gilmore model and the Lezzi and Prosperetti model are compared with those resulting from the Keller and Miksis model. It is shown that the variation of liquid density at bubble surface in a very short time interval around the end of the bubble collapse, which has been incorporated into the first two models, strongly influences the bubble cavitation dynamics at higher... 

The effects of liquid density variation at the bubble surface on the dynamics of a single acoustic cavitation bubble are numerically studied. The Gilmore model together with a comprehensive hydrochemical model is used. The evaporation and condensation of water vapor are included in the hydrochemical model. The simulation results are compared to those resulting from the widely known Keller-Miksis model, which assumes a constant liquid density at the bubble surface. The numerical results for a single argon bubble in water reveal that the pressure and the temperature inside the bubble in collapse phase significantly increase, when the non-constant liquid density is used. These differences... 

Worldwide interoperability for Microwave Access (WiMAX) is designed to support a wide range of Quality of Service (QoS) requirements for different applications. Unlike the single service networks, a priority based mechanism is needed for specifying the transmission order of packets belonging to different traffic sources according to their QoS characteristics, which is called packet scheduling. In WiMAX standard, packet scheduling algorithm is not defined and its design is left for researchers. In this work, we propose a distributed uplink packet scheduling algorithm. In the proposed algorithm, when uplink capacity cannot satisfy the required resource of connections, according to traffic... 

In this paper, some important circuit parameters of a monolayer armchair graphene nanoribbon (GNR) field effect transistor (GNRFET) in different structures are studied. Also, these structures are Ideal with no defect, 1SVGNRFET with one single vacancy defect, and 3SVsGNRFET with three SV defects. Moreover, the circuit parameters are extracted based on Semi Classical Top of Barrier Modeling (SCTOBM) method. The I-V characteristics simulations of Ideal GNRFET, 1SVGNRFET and 3SVsGNRFET are used for comparing with SCTOBM method. These simulations are solved with Poisson-Schrodinger equation self-consistently by using Non- Equilibrium Green Function (NEGF) and in the real space approach. The... 

Graphene nanoribbon field effect transistors are promising devices for beyond-CMOS nanoelectronics. Graphene is a semiconductor material with zero bandgap and its bandgap must be changed. One of the opening bandgap methods is using graphene nanoribbons. By applying a defect, there is more increase on band gap of monolayer armchair graphene nanoribbon field effect transistor. So, by applying more than one defect, we can reach to much more increase in bandgap of graphene nanoribbon field effect transistors (GNRFET). In this paper, double-gated monolayer armchair graphene nanoribbon field effect transistors (GNRFET) with one single vacancy (1SV) defect (so-called 1SVGNRFET)are simulated and... 

A superhydrophobic nanocomposite coating was fabricated using a simple procedure. The nanocomposite is composed of an acrylic copolymer and modified silica nanoparticles. The acrylic copolymer was prepared by free radical copolymerization of methyl methacrylate and dodeycl methacrylate monomers. Silica nanoparticles were synthesized and modified with an alkyl silane reagent, hexadecyltrimethoxysilane. A mixture of acrylic copolymer and modified silica nanoparticles, dispersed in dichloromethane, was then sprayed on glass and filter paper surface. Chemical composition and structure of the coatings were investigated by FTIR, FESEM, AFM, 1H-NMR and GPC. The wettability of the prepared coating... 

In this paper, two different statistical approaches are used for duration prediction of the Farsi language. These two statistical models are Neural Networks (NN) and Classification And Regression Trees (CART). The first step in this work was to create a database and develop a flexible feature extraction and selection module. In the next step, the output of the feature selection module was used to train both models. The results of the trained models are further studied to determine the most important parameters affecting the syllable duration in Farsi, The model accuracy is evaluated by using separate training and test data. In the third step of this work, ah automatic rule generator module... 

This paper proposes a finite-time stable chattering-free output feedback control method for rigid satellites equipped with single gimbal control moment gyro (SGCMG) actuators, considering dynamic uncertainties and external disturbances. The dynamics of a rigid satellite are first represented using the modified Rodrigues parameter (MRP) explanation, and then transformed into Lagrangian state space affine form. Because of cost or technical restrictions, angular velocity data are not always accessible for practical application. So angular velocity is considered to be unmeasurable. In order to avoid increasing mathematical calculations and designing separate observers to estimate external... 

Proliferation of photovoltaic (PV) panels may cause voltage increases in low voltage (LV) distribution feeders. This issue confines PV hosting capacity of the feeders. To overcome this issue and enable higher PV hosting capacity, a model to manage the operation cycles of the domestic electric water heater and heating, ventilation, and air conditioning loads in order to avoid the voltage rise, thereby increasing PV hosting capacity in LV feeders is presented in this study. The model respects users' thermal comfort by setting the associated temperatures within allowed ranges. To preserve customers' privacy, the presented model is then decomposed into a master problem and several sub-problems... 

Every year, the health of millions of people around the world is compromised by misdiagnosis, which sometimes could even lead to death. In addition, it entails huge financial costs for patients, insurance companies, and governments. Furthermore, many physicians’ professional life is adversely affected by unintended errors in prescribing medication or misdiagnosing a disease. Our aim in this paper is to use data mining methods to find knowledge in a dataset of medical prescriptions that can be effective in improving the diagnostic process. In this study, using 4 single classification algorithms including decision tree, random forest, simple Bayes, and K-nearest neighbors, the disease and its... 

The formation of water drops as a Newtonian fluid and formation of a shear-thinning non-Newtonian fluid, Carboxyl Methyl Cellulose (CMC) from a capillary into different bulk fluids are experimentally investigated. A high speed camera is used to visualize the images of the drops and an image-processing code employed to determine the drop properties from each image. It was found that the properties of the water drops when they are drooped into the liquids bulk fluids such as toluene and n-hexane are almost the same while they differed substantially when they were drooped into the air bulk fluid. It is shown that during the formation of water drop in all three kinds of bulk fluids, the drop... 

Gas tungsten arc welding of CK45 and AISI304 stainless steel was performed through preparation of different types of samples using ER308L and ERNi-1 wires. Welded samples were studied by different techniques including optical metallography, scanning electron microscopy equipped with energy dispersive X-ray spectroscopy (SEM-EDS), X-ray diffraction, hardness measurements and impact test. It was observed that in the buttered specimen, the structure of the weld metal was completely austenitic while the microstructure of unbuttered sample was duplex ferritic-austenitic. M23C6-type carbides were observed within the weld metal of both as-weld specimen types. Effects of different post-weld heat... 

A new magnetic heterogeneous copper catalyst was prepared by immobilization of copper ions onto a cross-linked polymeric nanocomposite composed of starch grafted polyacrylamide and functionalized Fe3O4 magnetic nanoparticles. The resulting support was loaded with large amounts of copper ions (1.6 mmol g-1). The prepared catalyst is highly active in Huisgen 1,3-dipolar cycloaddition reactions of different azides and alkynes at low catalyst amounts. Various corresponding 1,2,3-triazoles were produced with high yields in mild conditions. The catalyst was easily recovered and reused for ten cycles of reaction and no significant loss of catalytic activity was observed  

A noncovalent functionalization of the edges of reduced graphene oxide (RGO) with β-cyclodextrin-graft-hyperbranched polyglycerol (β-CD-g-HPG) was successfully performed via a host-guest interaction. The results showed that β-CD-g-HPG disperses the graphene sheets better than pure β-CD or HPG. The resulted supramolecular structure is stable in neutral water medium more than one week. However, in acidic medium the host-guest interaction is collapsed and graphene nanosheets precipitate. © 2017, Copyright © Taylor & Francis  

In the present study, a novel theoretical model is developed, based on the energy method, to predict the equivalent mechanical properties of a new morphing structure with zero Poisson's ratio, which is composed of continuous fiber reinforced composite struts. Due to the employing glass fiber in fabricating the proposed cruciform honeycomb, higher strength than the structures made of pure isotropic materials is obtained. The use of cells with a zero Poisson's ratio also increases the flexural strength of the structure. In the continuation of the paper, by examining the geometric effects on the equivalent properties, a parametric study is performed. Then, using the appropriate failure... 

A novel superabsorbent composite based on kappa-Carrageenan (κC) was prepared by graft copolymerization of acrylamide (AAm) onto κC in the presence of bentonite powder using methylenebisacrylamide (MBA) as a crosslinking agent, ammonium persulfate (APS) as an initiator, and sodium carbonate as a pore-forming agent. The swelling behavior in distilled water and in solutions with different pH values was investigated. The results indicated that with increasing carrageenan/bentonite weight ratio, the swelling capacity is increased but the gel content is decreased. The swelling rate of the hydrogels was improved by introducing sodium carbonate as pore-forming agent. The prepared superadsorbent...