Sharif Digital Repository

Aromatic aldehydes and ketones are readily acetalized or ketalized under microwave irradiation in the presence of water as a solvent  

A four-step synthetic strategy was applied to achieve novel methacrylic monomers. 5-Norbornene-2,2-dimethanol was prepared from a Diels–Alder reaction of cyclopentadiene and acrolein, followed by the treatment of the adduct with an HCHO/KOH/MeOH solution. The resulting 1,3-diol (1) was then acetalized with different aromatic aldehydes having OH groups on the ring to produce four spiroacetal derivatives. The reaction of methacryloyl chloride with the phenolic derivatives led to four new methacrylic monomers that were identified spectrochemically (mass, FTIR, 1H-NMR, and 13C-NMR spectroscopy). Free radical solution polymerization was used to prepare novel spiroacetal–norbornene containing... 

This paper presents a method for optimizing SFDR in differential active-RC filters. Simple analytical expressions for noise and third-order intermodulation (IM3) distortion in active-RC filters are derived. The nonlinear behavior of two-stage Miller-compensated op amps, which are extensively used in active-RC implementations, is also modeled. These expressions and models are used to maximize SFDR in active-RC filters by means of proper admittance scaling and optimizing the share of each op amp in the total power consumption. It is shown that both the power consumption of the filter and its area can be significantly reduced, for a given SFDR, by exploiting the presented method  

This paper presents a design procedure for a wideband 6-18-GHz monolithic microwave integrated circuit highpower amplifier (HPA) in 0.25-μm AlGaAs-InGaAs pHEMT technology. The design is mainly focused on the realization of the passive circuits to provide the required low-loss and wideband impedance transformation networks. The two-stage GaAs HPA achieves an average output power of 39.6 dBm and a peak output power of 40.5 dBm at 11 GHz, in pulsed mode operation, with a small-signal gain of S21 > 10 dB over the entire bandwidth. The average power added efficiency (PAE) is 22%, with a peak PAE of 29% at 11 GHz. The HPA chip occupies an area of 5×3.6 mm2. The achieved output power and the... 

This paper presents a general method for real-time adaptation of wireless receivers according to the prevailing reception conditions. In order to maintain the desired signal quality at the minimum possible power dissipation, the method performs an optimal trade-off between noise, linearity, and power consumption in the building blocks of the receiver. This is achieved by continuously monitoring the signal-to-noise plus interference ratio (SNIR) and accordingly tuning the adaptation parameters embedded in the receiver design. A prototype DVB-H receiver chip, implemented in a standard 0.18-μ m CMOS process, is used as the test vehicle. By properly trading noise with linearity in the receiver,... 

A new approach for the design of two-stage Miller-compensated CMOS op amps is presented. The paper studies the basic relations between power consumption, unitygain bandwidth, the biasing region, technology parameters, and the external capacitive load. As a result, simple and efficient design guides are provided to achieve the minimum possible power consumption for the given specifications and for short-channel devices. It is shown that the conventional design procedures do not always result in minimum power op amps. The presented results are also verified by Spectre simulations  

A highly linear X-band low-noise amplifier (LNA) is proposed and implemented in a standard 0.18-μm CMOS technology. The LNA features both high and low-gain operation modes. In its normal high-gain mode, the LNA shows a small-signal gain of 13.6 dB with an IIP3 of +9.5 dBm and a noise figure of 4.7 dB. The two-stage amplifier draws 90 mA from the 3.3V power supply to achieve +14.8 dBm output P1dB (+2.2 dBm input P1dB). In the low-gain mode, the gain is reduced by about 10 dB to further enhance the linearity and to accommodate very large blockers. Accordingly, the input P1dB is enhanced to +13.7 dBm while the noise figure is increased by 8.1 dB. A technique is also introduced to maintain the... 

This paper presents a highly-linear transceiver core chip for X-band phased-array systems with two RX and one TX channels. Implemented in a standard 0.18-μm CMOS technology, the core chip provides 6-bit phase control (with rms error <2°) and 6-bit gain control (with rms error <0.6 dB) both within the 8.5–11.5 GHz frequency band. Improved accuracy is also available by digital calibration in narrowband applications. The receivers achieve a gain of 13.5 dB, an IIP3 of +10.3 dBm, and a noise figure of 8.2 dB, while drawing 170 mA per channel from the 3.3 V supply. The chip also provides an additional low-gain mode which further enhances IIP3 to +19.1 dBm and the input-referred P1dB to +11.4 dBm.... 

A combination of silica chloride and wet SiO2 was used as an effective deacetalizating agent for the conversion of acetals to their corresponding carbonyl derivatives under mild and heterogeneous condition