Sharif Digital Repository

A heat-transfer model was formulated to determine the distribution of temperature within a bioheap of chalcopyrite of Sarcheshmeh copper mine. Bioleaching employs mixed mesophilic and thermophilic microbes for Cu extraction. Thermophiles are better than mesophiles to dissolve CuFeS2. The solution irrigation and aeration rates were taken into account as the main operational factors. The model was validated by comparing the temperature profiles of test columns with those of bioheap. The model was used to find the optimal ratio of irrigation to aeration. It was found that when the solution was fed at a flow rate of 5 kg/m2 h and air was blown at a flow rate of 7.5 kg/m2 h, the transition from a... 

A novel amperometric non-enzymatic glucose sensor is designed by the facile preparation method. It is made by electrodeposition of Cu clusters and converting them to Cu(OH)2 nanotubes (Cu(OH)2NTs) arrays along with thin-film electro-polymerized of spindle-shaped polypyrrole (PPy@Cu(OH)2NTs), which have been doped by using sodium Benzene-1,3-disulfonate as an anion dopant. Various electrochemical methods investigate the electrochemical performance of the modified electrode toward glucose detection. Under the optimized conditions, a significant electrochemical response improvement is observed toward the electro-oxidation of glucose on the PPy@Cu(OH)2NTs electrode's surface relative to the... 

Hydroxyapatite nanorods aligned with ultrahigh crystallinity and high-yield were successfully synthesized through a hydrothermal approach. In this experiment, a new composition of cetyltrimethylammonium bromide ((CH 3(CH2)15N+(CH3) 3Br-) was designated as CTAP)/Ca(NO3) 2/ (NH4)2HPO4/NaOH and distilled water under hydrothermal condition, to synthesize single crystal HAp nanorods with diameter of 20 ± 10 nm and length of 80 ± 20 nm, was introduced. Crystal phases were determined by X-ray diffraction (XRD). Scanning electron microscope (SEM) was applied to investigate the morphology. The microstructure of the HAp products were further observed by transmission electron microscope (TEM) and high... 

Learning a foreign language encompasses a process of trial and error that can lead to the progression of the learner's interlanguage, meaning that the learners make use of their language knowledge that receives feedback and brings about progress through diagnosis of the problems and being corrected by the teacher. Therefore, there exists a need to analyze the underlying reasons causing the students to remain taciturn with a low willingness to communicate (WTC) during a language class. There has been much work done investigating the role of the learner's stable personal characteristics (traits) along with their situational changes at a specific time (states) that influence the student's... 

Accurate system identification (SI) is essential for flight controller design of unmanned aerial vehicles and microaerial vehicles (MAVs). SI can be performed either in frequency or time domain using flight test data. As flight testing is often costly and may even lead to catastrophic events before some flight stability analysis is at hand, a low-cost 5 degree-of-freedom free motion platform (FMP) is designed and used for initial identification of MAVs via wind tunnel testing. A typical MAV is constructed as a test case and equipped with inertial sensors for testing and validation purposes. The proposed FMP allows for both rotational as well as translational motions that in turn provide for... 

Using 3-D scanned data to analyze and extract pore network plays a vital role in investigation of porous media's characteristics. In this paper, a new simple method is developed to detect pores and throats for analyzing the connectivity and permeability of the network. This automated method utilizes some of the common and well-known image processing functions which are widely accessible by researchers and this has led to an easy algorithm implementation. In this method, after polishing and quality control of images, using city-block distance function and watershed segmentation algorithm, pores and throats are detected and 3-D network is produced. This method can also be applied on 2-D images... 

In this paper, we try to recognize and distinguish different groups of arrhythmia using novel features which have been obtained from the heart rate's phase space in recent years. For this purpose, we used Triangular Phase Space Mapping (TPSM) and Parabolic Phase Space Mapping (PPSM). For recognition, we used three groups of 15 subjects using the Physionet database (Arrhythmia, Congestive Heart Failure (CHF), and Atrial Fibrillation (AF)) with Normal Sinus Rhythm (NSR). The obtained features discriminate arrhythmia from NSR by p