Sharif Digital Repository

A study was performed to investigate how different trunk and knee positions while holding static loads affect the lumbar curvature and internal loads on the lumbar spine at L4-L5. Ten healthy male subjects participated in this study. Two inclinometers were used to evaluate the curvature of lumbar spine, lordosis, while a 3D static biomechanical model was used to predict the spinal compression and shear forces at L4-L 5. Eighteen static tasks while holding three level of load (0, 10 and 20 kg), two levels of knee position (45 and 180° of flexion) and three levels of trunk position (neutral, 15 and 30 degree of flexion) were simulated for 10 healthy male subjects. The results of this study... 

Background: The bio-oxidation of ferrous iron is a potential industrial process in the regeneration of ferric iron and the removal of H2S in combustible gases. Bio-oxidation of ferrous iron may be an alternative method of producing ferric sulfate, which is a reagent used for removal of H2S from biogas, tail gas and in the pulp and paper industry. For practical use of this process, this study evaluated the optimal pH and initial ferric concentration. pH control looks like a key factor as it acts both on growth rate and on solubility ofmaterials in the system. Results: Process variables such as pH and amount of initial ferrous ions on oxidation by A. ferrooxidans and the effects of process... 

The oxidation of ferrous iron (Fe2+) in solution using Acidithiobacillus ferrooxidans has industrial applications exclusively in the regeneration of ferric iron (Fe3+) as an oxidizing agent for the removal of hydrogen sulfide from waste gases, desulfurization of coal, leaching of non-ferrous metallic sulfides and treatment of acid mine drainage. The aim of this investigation was to increase the bio-oxidation rate of ferrous sulfate by using immobilized cells. Rate of Fe2+ oxidation was determined in a packed-bed bioreactor configuration with monolithic particles being used as support material. Biooxidation of ferrous iron by immobilized cells was investigated in repeated batch culture and... 

Evaluation of spinal loads in patients with low back pain (LBP) is essential to prevent further lumbar disorders. Many studies have investigated the relationship between lifting task variables and lumbar spine loads during manual lifting activities. The nature of the external load (stable versus unstable loads) is an important variable that has received less attention. Therefore, the present study aimed to measure trunk kinematics and estimate compressive-shear loads on the lumbar spine under lifting a 120 N stable load and 120 ± 13.63 N sensual unstable load in 16 healthy and 16 non-specific LBP individuals during lifting activities. The maximal lumbar loads were estimated using a... 

The aim of this research work is to investigate sorption characteristic of acid treated brown algae Sargassum bevanom (acid treated S. bevanom) for the removal of Cr(VI) ions from aqueous solutions. The acid-treated alga was prepared by transferring the S. bevanom into 0.5. M HCl and then stirring the mixture at 300. rpm for 6. h at room temperature. The sorption of Cr(VI) ions by batch method is carried out. The optimum conditions of biosorption were found to be: a biomass dose of 0.7. g in 100. ml of Cr(VI), contact time of 110. min and pH 3, respectively. In optimum condition, removal efficiency was 89.64%. It was found that temperature has a positive effect on the removal efficiency.... 

Multiple joint interactions are critical to produce stable coordinated movements and can be influenced by low back pain and task conditions. Inter-segmental coordination pattern and variability were assessed in subjects with and without chronic nonspecific low back pain (CNSLBP). Kinematic data were collected from 22 CNSLBP and 22 healthy volunteers during repeated trunk flexion-extension in various conditions of symmetry, velocity, and loading; each at two levels. Sagittal plane angular data were time normalized and used to calculate continuous relative phase for each data point. Mean absolute relative phase (MARP) and deviation phase (DP) were derived to quantify lumbar-pelvis and... 

Objective: This study aimed to employ nonlinear dynamic approaches to assess trunk dynamic stability with speed, symmetry, and load during repetitive flexion-extension (FE) movements for individuals with and without nonspecific low back pain (NSLBP). Background: Repetitive trunk FE movement is a typical work-related LBP risk factor contingent on speed, symmetry, and load. Improper settings/adjustments of these control parameters could undermine the dynamic stability of the trunk, hence leading to low back injuries. The underlying stability mechanisms and associated control impairments during such dynamic movements remain elusive. Method: Thirty-eight male volunteers (19 healthy, 19 NSLBP)... 

Objective: This study aimed to employ nonlinear dynamic approaches to assess trunk dynamic stability with speed, symmetry, and load during repetitive flexion-extension (FE) movements for individuals with and without nonspecific low back pain (NSLBP). Background: Repetitive trunk FE movement is a typical work-related LBP risk factor contingent on speed, symmetry, and load. Improper settings/adjustments of these control parameters could undermine the dynamic stability of the trunk, hence leading to low back injuries. The underlying stability mechanisms and associated control impairments during such dynamic movements remain elusive. Method: Thirty-eight male volunteers (19 healthy, 19 NSLBP)... 

A single-degree-of-freedom model is considered for flexible exercise bars based on the lumped-element approach. By considering the side segment of a flexible bar as a cantilever beam with an equivalent mass at the free end, its free-vibration response, as well as the forced response under the excitation of the grip, are expressed parametrically. Experiments are performed on a particular flexible bar (FLEXI-BAR) in order to obtain numerical values for quantifying the model's parameters. The model is also computationally simulated to study the response of the flexible bar to various excitations. The results are imported into a multi-segment musculoskeletal software (AnyBody), where the effect... 

In vivo dose-dependent effects of nanoscale graphene oxide (NGO) sheets on reproduction capability of Balb/C mice were investigated. Biodistribution study of the NGO sheets (intravenously injected into male mice at dose of ∼2000 μg/mL or 4 mg/kg of body weight) showed a high graphene uptake in testis. Hence, in vivo effects of the NGO sheets on important characteristics of spermatozoa (including their viability, morphology, kinetics, DNA damage and chromosomal aberration) were evaluated. Significant in vivo effects was found at the injected concentrations ≥200 μg/mL after (e.g., ∼45% reduction in sperm viability and motility at 2000 μg/mL). Observation of remarkable DNA fragmentations and... 

Asian red ginseng was used for green reduction of chemically exfoliated graphene oxide (GO) into reduced graphene oxide (rGO). The reduction level and electrical conductivity of the ginseng-rGO sheets were comparable to those of hydrazine-rGO ones. Reduction by ginseng resulted in repairing the sp 2 graphitic structure of the rGO, while hydrazine-rGO showed more defects and/or smaller aromatic domains. The ginseng-rGO sheets presented a better stability against aggregation than the hydrazine-rGO ones in an aqueous suspension. Whilst the hydrophobic hydrazine-rGO films exhibited no toxicity against human neural stem cells (hNSCs), the hydrophilic GO and ginseng-rGO films (as more... 

Vigorous debates have taken place within and between many countries about regulatory policy regimes covering the assessment and approval of genetically modified (GM) crops. In Iran, a very vigorous and hotly contested policy debate concerning legislation covering GM crops occurred between 2004 and 2009, but it was confined within government circles with almost no public discussion. This paper analyses the Iranian policy-making process in the period 2006-9. It explains how and why a stalemate arose in disputes between ministries and departments. The chosen analytical framework draws mainly on the regulation of technological risks and the analysis of public policy-making. It deploys the... 

A μ-way latin trade of volume s is a set of μ partial latin rectangles (of inconsequential size) containing exactly the same s filled cells, such that if cell (i, j) is filled, it contains a different entry in each of the μ partial latin rectangles, and such that row i in each of the μ partial latin rectangles contains, set-wise, the same symbols and column j, likewise. In this paper we show that all μ-way latin trades with sufficiently large volumes exist, and state some theorems on the non-existence of μ-way latin trades of certain volumes. We also find the set of possible volumes (that is, the volume spectrum) of μ-way latin trades for μ = 4 and 5. (The case μ = 2 was dealt with by Fu,... 

The set of integers k for which there exist three latin squares of order n having precisely k cells identical, with their remaining n2 -k cells different in all three latin squares, denoted by I3[n], is determined here for all orders n. In particular, it is shown that I3[n] = {0,.,n2 -15}U [n2 - 12,n2-9,n2], for n ≫8. ©2002 Eisevier Science B.V. All rights reserved  

Coronary angiography is a vital instrument to detect the prevailing of vascular diseases, and accurate vascular segmentation acts a crucial role for proper quantitative analysis of the vascular tree morphological features. Level set methods are popular for segmenting the coronary arteries, but their performance is related to suitable start-up and optimum setting of regulating parameters, essentially done manually. This research presents a novel fuzzy level set procedure with the objective of segmentation of the coronary artery tree in 2-D X-ray angiography as automatically. It is clever to clearly develop from the early segmentation with spatial fuzzy grouping. The adjusting parameters of... 

Visual attributes are great means of describing images or scenes, in a way both humans and computers understand. In order to establish a correspondence between images and to be able to compare the strength of each property between images, relative attributes were introduced. However, since their introduction, hand-crafted and engineered features were used to learn increasingly complex models for the problem of relative attributes. This limits the applicability of those methods for more realistic cases. We introduce a deep neural network architecture for the task of relative attribute prediction. A convolutional neural network (ConvNet) is adopted to learn the features by including an... 

We present the first public code for the calculation of the astrometric centroid shift occurring during microlensing events. The computation is based on the contour integration scheme and covers single and binary lensing of finite sources with arbitrary limb darkening profiles. This allows for general detailed investigations of the impact of finite source size in astrometric binary microlensing. The new code is embedded in version 3.0 of vbbinarylensing, which offers a powerful computational tool for extensive studies of microlensing data from current surveys and future space missions. © 2021 The Author(s) Published by Oxford University Press on behalf of Royal Astronomical Society