Sharif Digital Repository

In the present article, a new model for inverse Hall-Petch relation in nanocrystalline materials has been proposed. It is assumed that lattice distortion along grain boundaries can cause internal stresses and high internal stresses along grain boundaries can promote the grain boundary yielding. The designed model was then verified using the nanocrystalline-copper data. The minimum grain size for inverse Hall-Petch relation is determined to be about 11 nm for Cu. © 2008 ASM International  

Present study is aimed to investigate the relationship between blade shape of Savonius rotor and its optimum overlap, an important parameter that can improve the rotor's performance superbly. To set a relation between rotor's shape and its overlap, a new parameter called "trailing angle" was introduced in this study and by a novel design method, several models were designed to represent a wide range of trailing angles. The investigation has been carried out by using Reynolds Stress Method (RSM) through ANSYS Fluent commercial software package. The application of the method was validated by comparing the results of a conventional model with experimental data acquired from one of the... 

This paper analytically determines the nondetection zone (NDZ) of an active islanding detection method, and proposes a solution to obviate the NDZ. The method actively injects a negative-sequence current through the interface voltage-sourced converter (VSC) of a distributed generation (DG) unit, as a disturbance signal for islanding detection. The estimated magnitude of the corresponding negative-sequence voltage at the PCC is used as the islanding detection signal. In this paper, based on a laboratory test system, the performance of the islanding detection method under UL1741 anti-islanding test conditions is evaluated. Then, determining the NDZ of the method and proposing the... 

This paper proposes a control strategy for the autonomous (islanded) operation of a four-wire, electronically-coupled distributed generation (DG) unit which can feed a highly unbalanced load, e.g., due to the presence of single-phase loads. In the grid-connected mode, the power-electronic interface of the DG unit enables the exchange of real and reactive power with the distribution network, based on the conventional dq-frame current control strategy. The current control scheme is disabled subsequent to the detection of an islanding event, and the proposed controller is activated. The proposed control strategy utilizes: i) an internal oscillator to maintain the island frequency and ii) a... 

This paper presents stability analysis of a distributed generation (DG) controller (1), in an islanded mode, based on the Mapping Theorem and the Zero Exclusion Condition, and validates the results based on a laboratory scale experimental setup. The DG unit is interfaced to the host system through a voltage-sourced converter (VSC). The control strategy regulates the load voltage at the desired value in the islanded mode, despite uncertainties in the load parameters. The frequency of the island is controlled in an open loop manner by an internal oscillator. The experimental results show that the controller provides robust voltage control for a wide range of load parameters, and even maintains... 

This paper presents a decentralized control strategy for the autonomous (islanded) operation of parallel connection of two distributed generation (DG) units. The DG units are electronically interfaced to the host grid at the same point of common coupling (PCC), where the local load is also supplied. In the grid-connected mode, the voltage-sourced converter (VSC) of each DG unit controls the exchange of real and reactive power components with the host grid, based on the conventional dq-current control strategy. In the islanded mode, one of the DG units provides voltage and frequency control for the island, and the other DG unit continues to operate with the pre-islanding dq-current control... 

Purpose: Dams require high-volume of construction materials and operations over the life cycle. This paper aims to select a proper type of dam structure that can significantly contribute to the sustainability of dam projects. Design/methodology/approach: This research proposes a complementary fuel consumption and carbon dioxide (CO2) emission assessment method for the alternate dam structure types to assist decision-makers in selecting sustainable choices. Related equations are developed for two common earthen and rock-fill dam structures types in Iran. These equations are then successfully applied to two real dam project cases where the significance of the achieved results are assessed and... 

Purpose: Dams require high-volume of construction materials and operations over the life cycle. This paper aims to select a proper type of dam structure that can significantly contribute to the sustainability of dam projects. Design/methodology/approach: This research proposes a complementary fuel consumption and carbon dioxide (CO2) emission assessment method for the alternate dam structure types to assist decision-makers in selecting sustainable choices. Related equations are developed for two common earthen and rock-fill dam structures types in Iran. These equations are then successfully applied to two real dam project cases where the significance of the achieved results are assessed and... 

The growing rate of population and technological advancement have led to an increase in natural resource consumption, which has caused irreparable damage to the environment. The implementation of green supply chain management is one of the most effective ways to deal with environmental degradation. Therefore, in this paper, a bi-objective mixed integer linear programming model is developed to design a green supply chain network. In the proposed model, the possibility of customer storage, being faced with shortage, locating of distribution centres, green vehicle routing problem, split delivery, multi-depot vehicle routing problem (VRP), capacitated VRP, and uncertainty in demands will be... 

Supplier selection is an important and challenging problem in sustainable supply chain management. We propose a dynamic decision support system (DSS) for sustainable supplier selection in circular supply chains. Unlike the linear take-make-waste-dispose production systems, circular supply chains are nonlinear make-waste-recycle production systems with zero-waste vision. The proposed DSS allows users to customize and weight their economic, social, and circular criteria with a fuzzy best-worst method (BWM) and select the most suitable supplier with the fuzzy inference system (FIS). Machine learning is used to maintain and synthesize the criteria scores for the suppliers after each supplier... 

Supplier selection is an important and challenging problem in sustainable supply chain management. We propose a dynamic decision support system (DSS) for sustainable supplier selection in circular supply chains. Unlike the linear take-make-waste-dispose production systems, circular supply chains are nonlinear make-waste-recycle production systems with zero-waste vision. The proposed DSS allows users to customize and weight their economic, social, and circular criteria with a fuzzy best-worst method (BWM) and select the most suitable supplier with the fuzzy inference system (FIS). Machine learning is used to maintain and synthesize the criteria scores for the suppliers after each supplier... 

A linear time-invariant (LTI) robust servomechanism controller for islanded (autonomous) operation of a distributed generation (DG) unit and its local load is proposed. The DG unit utilizes a voltage-sourced converter (VSC) as the interface medium. The controller design is obtained by introducing a new optimal controller design procedure, in conjunction with a proposed non-conservative robustness constraint. The proposed controller utilizes 1) an internal oscillator for frequency control and 2) a robust servomechanism controller (RSC) to regulate the island voltage. Despite uncertainty of the load parameters, the proposed controller guarantees robust stability and pre-specified performance... 

This paper presents stability analysis of a distributed generation (DG) controller [1], in an islanded mode, based on the Mapping Theorem and the Zero Exclusion Condition, and validates the results based on a laboratory scale experimental setup. The DG unit is interfaced to the host system through a voltage-sourced converter (VSC). The control strategy regulates the load voltage at the desired value in the islanded mode, despite uncertainties in the load parameters. The frequency of the island is controlled in an open loop manner by an internal oscillator. The experimental results show that the controller provides robust voltage control for a wide range of load parameters, and even maintains...