Sharif Digital Repository

Rapid urbanization and consuming lifestyles have intensified air pollution in urban areas. Air pollution in megacities has imposed severe environmental damages to human health. Proper management of the issue necessitates identification of the share of emission sources. Therefore, numerous research works have studied the apportionment of the total emissions and observed concentrations among different emissions sources. In this research, a comprehensive review is conducted to compare the source apportioning results for ambient air PM2.5 in the megacity of Tehran, the capital of Iran. One hundred seventy-seven pieces of scientific literatures, published between 2005 and 2021, were reviewed. The... 

Drawing on prior reports highlighting the redox mediator properties of powdered activated carbon (PAC), this study was designed to evaluate these properties to enhance the decolorization of azo dye by Klebsiella quasipneumoniae GT7. It was found that the presence of 0.5 % PAC in the medium increased the biodecolorization rate early in incubation. Chemical analysis revealed that dye conversion into aromatic amines occurred in microbial systems both with and without PAC. However, at initial dye concentrations (Cid) of 2 mM or higher, some dye remained on the PAC surface and in the medium. In contrast, the PAC-free system achieved nearly 100 % biodecolorization at all initial dye... 

In the present work, we investigated the characteristics of polycyclic aromatic hydrocarbons (PAHs) and metal(loid)s in indoor/outdoor PM10, PM2.5, and PM1 in a retirement home and a school dormitory in Tehran from May 2012 to May 2013. The results indicated that the annual levels of indoor and outdoor PM10 and PM2.5 were much higher than the guidelines issued by the World Health Organization (WHO). The most abundant detected metal(loid)s in PM were Si, Fe, Zn, Al, and Pb. We found higher percentages of metal(loid)s in smaller size fractions of PM. Additionally, the results showed that the total PAHs (ΣPAHs) bound to PM were... 

Systemic inflammation biomarkers have been associated with risk of cardiovascular morbidity and mortality. We aimed to clarify associations of acute exposure to particulate matter (PM10(PM < 10 μm), PM2.5-10(PM 2.5–10 μm), PM2.5(PM < 2.5 μm), PM1-2.5(PM 1–2.5 μm), and PM1 (PM < 1 μm)) with systemic inflammation using panels of elderly subjects and healthy young adults. We followed a panel of 44 nonsmoking elderly subjects living in a retirement home and a panel of 40 healthy young adults living in a school dormitory in Tehran city, Iran from May 2012 to May 2013. Blood biomarkers were measured one every 7–8 weeks and included white blood cells (WBC), high sensitive C-reactive protein... 

There is limited evidence for short-term association between mortality and ambient air pollution in the Middle East and no study has evaluated exposure windows of about a month prior to death. We investigated all-cause non-accidental daily mortality and its association with fine particulate matter (PM2.5), nitrogen dioxide (NO2), and the Air Quality Index (AQI) from March 2011 through March 2014 in the megacity of Tehran, Iran. Generalized additive quasi-Poisson models were used within a distributed lag linear modeling framework to estimate the cumulative effects of PM2.5, NO2, and the AQI up to a lag of 45 days. We further conducted multi-pollutant models and also stratified the analyses by... 

Accurate system identification (SI) is essential for flight controller design of unmanned aerial vehicles and microaerial vehicles (MAVs). SI can be performed either in frequency or time domain using flight test data. As flight testing is often costly and may even lead to catastrophic events before some flight stability analysis is at hand, a low-cost 5 degree-of-freedom free motion platform (FMP) is designed and used for initial identification of MAVs via wind tunnel testing. A typical MAV is constructed as a test case and equipped with inertial sensors for testing and validation purposes. The proposed FMP allows for both rotational as well as translational motions that in turn provide for... 

In this paper, we address global non-fragile control and synchronization of a new fractional order chaotic system. First we inspect the chaotic behavior of the fractional order system under study and also find the lowest order (2.49) for the introduced dynamics to remain chaotic. Then, a necessary and sufficient condition which can be easily extended to other fractional-order systems is proposed in terms of Linear Matrix Inequality (LMI) to check whether the candidate state feedback controller with parameter uncertainty can guarantee zero convergence of error or not. In addition, the proposed method provides a global zero attraction of error that guarantees stability around all existing... 

A single-degree-of-freedom model is considered for flexible exercise bars based on the lumped-element approach. By considering the side segment of a flexible bar as a cantilever beam with an equivalent mass at the free end, its free-vibration response, as well as the forced response under the excitation of the grip, are expressed parametrically. Experiments are performed on a particular flexible bar (FLEXI-BAR) in order to obtain numerical values for quantifying the model's parameters. The model is also computationally simulated to study the response of the flexible bar to various excitations. The results are imported into a multi-segment musculoskeletal software (AnyBody), where the effect... 

The first step to locate Partial Discharge in power transformers is to find a model that can clearly explain the behavior of the winding in high-frequency. The detailed model is one of the models used for the study of PD. One of the fundamental problems of the described model is to find its parameters. And the accuracy in calculating these parameters has significant impact on reducing the simulation error and PD locating. The current paper seeks to calculate the parameters of the detailed model 20kv distribution transformer winding by using the finite element method (FEM). Comparing the results of this model with pulse waveforms obtained from the PD to the winding in the laboratory... 

While the differentiation factors have been widely used to differentiate mesenchymal stem cells (MSCs) into various cell types, they can cause harm at the same time. Therefore, it is beneficial to propose methods to differentiate MSCs without factors. Herein, magnetoelectric (ME) nanofibers were synthesized as the scaffold for the growth of MSCs and their differentiation into neural cells without factors. This nanocomposite takes the advantage of the synergies of the magnetostrictive filler, CoFe 2 O 4 nanoparticles (CFO), and piezoelectric polymer, polyvinylidene difluoride (PVDF). Graphene oxide nanosheets were decorated with CFO nanoparticles for a proper dispersion in the polymer through... 

We have investigated the piezoelectric response of the hydrogenated graphene oxide (H-G-SiO2) stacks both experimentally and theoretically. The piezoresponse force microscopy method and density-functional theory (DFT) calculations were used to study the piezoresponse effect of this structure from both experimental and computational point of views. A mono-layer graphene, made by chemical vapour deposition method, is deposited on Si/SiO2 substrate and its surface is then functionalized with hydrogen atoms. The vertical piezoresponse, observed by piezoresponse force microscopy, is measured to be about 2146 pC N-1, that is comparable to the reported state of the art piezoelectric materials such... 

Design of an Ultra-Wideband 3-dB quadrature (90°) Hybrid using ADS and HFSS softwares plus Measurement report are presented. Simultaneous Use of these two softwares lead to fast and accurate design procedure. The coupler is realized in broadside stripline and with the connection of coupled regions in tandem structure. The measured data agrees well with the expected values from simulations, and shows a good ultra wide bandwidth response over the frequency range of 1-10 GHz. Measurements showed an amplitude unbalance of ±1.5 dB, a phase unbalance of 90°±7° , and an isolation and a return loss characteristics of more than 14 dB over the frequency of 1 to 10 GHz  

The Ni-base superalloy GTD-111 is employed in high-power stationary gas turbines because of its high temperature strength and oxidation resistance. The temperature dependence of the tensile behavior of GTD-111 has been studied by tensile tests in the temperature range of 25-900°C with a constant strain rate of 10-4s-1. The results showed an abnormal tensile property variation with increasing temperature. The yield strength decreased slightly with temperature up to about 650°C and then increased between 650 and 750°C. Above 750°C, a rapid decrease in the yield strength was found. The tensile strength showed a similar behavior except for its maximum that occurred at 650°C. The elongation... 

Bioinspired materials can mimic the stem cell environment and modulate stem cell differentiation and proliferation. In this study, biomimetic micro/nanoenvironments were fabricated by cell-imprinted substrates based on mature human keratinocyte morphological templates. The data obtained from atomic force microscopy and field emission scanning electron microscopy revealed that the keratinocyte-cell-imprinted poly(dimethylsiloxane) casting procedure could imitate the surface morphology of the plasma membrane, ranging from the nanoscale to the macroscale, which may provide the required topographical cell fingerprints to induce differentiation. Gene expression levels of the genes analyzed... 

Grid computing is a type of parallel and distributed system that provides the possibility of sharing, choosing and collecting the autonomous resources (such as computer, software, databases, and equipments) that are distributed geographically. Resource discovery is one of the key subjects in distributed systems and especially Grids. We should consider that Grid consists of different applications that each of them consist of different hardware and software resources, therefore recognizing these resources is important in a Grid system. Classical approaches to Grid resource discovery are either centralized or hierarchical [1] (and will maybe prove inefficient as the scale of Grid systems... 

Recently, a renewed interest arises in the application of nanotechnology for the upstream petroleum industry. In particular, adding nanoparticles to fluids may drastically benefit enhanced oil recovery (EOR) and improve well drilling, by changing the properties of the fluid, rocks wettability alteration, advanced drag reduction, strengthening the sand consolidation, reducing the interfacial tension and increasing the mobility of the capillary trapped oil. In this study, we focus on roles of clay nano-particles on polymer viscosity. Polymer-flooding schemes for recovering residual oil have been in general less than satisfactory due to loss of chemical components by adsorption on reservoir...