Sharif Digital Repository

A millimeter wave H-plane duplexer using E-plane filters has been designed. T-junction is used for connecting the channel filters compensated by cylindrical post and analyzed by integral contour method. Moreover the junction discontinuity effects have been taken into account. The combination of filters and compensated T-junction allows for low-cost manufacturing. The E-plane filters are analyzed separately, by mode matching method. The scattering parameters of the combination of filters and T-junction are obtained. The diameter and position of the compensating rod and length of T arms are optimized to achieve desired performance. This procedure saves time and memory in computations. The 38... 

This article investigates the effect of nanoparticles on mass transfer in the liquid–liquid extraction for the chemical system of n-butanol–succinic acid–water. For this purpose, nanofluids containing various concentrations of ZnO, carbon nanotubes (CNT), and TiO2 nanoparticles in water, as base fluid, were prepared. To examine the flow mode effect on mass transfer rate, different fluid modes including dropping and jetting were employed in the process. Results show that mass transfer rate enhancement depends on the kinds and the concentration of nanoparticles and the modes of flow. It was observed that after adding nanoparticles, the mass transfer rate significantly increases up to two-fold... 

In tunneling projects and open-pit mines, drilling and blasting is a common method for fragmenting the rock masses. Although fragmentation is the main aim of blasting, the adverse effects such as air-overpressure (AOp) and ground vibration are unavoidable. Among these unwanted effects, AOp is considered as one of the most important effects which can cause damage to nearby structures. Therefore, precise estimation of AOp is required for minimizing the environmental problems. This article proposes three new models for predicting blast-induced AOp at Shur river dam area, Iran, optimized by particle swarm optimization (PSO). For this aim, 80 blasting events were investigated and the requirement... 

In tunneling projects and open-pit mines, drilling and blasting is a common method for fragmenting the rock masses. Although fragmentation is the main aim of blasting, the adverse effects such as air-overpressure (AOp) and ground vibration are unavoidable. Among these unwanted effects, AOp is considered as one of the most important effects which can cause damage to nearby structures. Therefore, precise estimation of AOp is required for minimizing the environmental problems. This article proposes three new models for predicting blast-induced AOp at Shur river dam area, Iran, optimized by particle swarm optimization (PSO). For this aim, 80 blasting events were investigated and the requirement... 

Using multiple antennas at the transmit and receive sides of a passive radar brings both the benefits of MIMO radar and passive radar. However one of the obstacles arisen in such configuration is the receive antennas placement in proper positions so that the radar performance is improved. Here we just consider the case of positioning one receiver among multiple illuminators of opportunity. Indeed it is a start for the solution of optimizing the geometry of the multiple receivers in a passive radar  

SbCl3 supported on montmorillonite K-10 is an efficient catalyst for the ring opening of epoxides with aromatic amines under solvent-free conditions and microwave irradiation to give the corresponding b-amino alcohols in high yields with high regioselectivity  

In this paper, we consider an integrated sensing and communication (ISAC) system with wireless power transfer (WPT) where an unmanned aerial vehicle (UAV)-based radar serves a group of energy-limited communication users in addition to its sensing functionality. In this architecture, the radar senses the environment in phase 1 (namely sensing phase) and mean-while, the communications users (nodes) harvest and store the energy from the radar transmit signal. The stored energy is then used for information transmission from the nodes to UAV in phase 2, i.e., uplink phase. Performance of the radar system depends on the transmit signal as well as the receive filter; the energy of the transmit... 

One of the important obstacles in MIMO (Multiple Input Multiple Output) radars is the issue of designing proper transmit signals. Indeed, the capability of signal design is a significant advantage in MIMO radars, through which, the system can achieve much better performance. Many different aspects of this performance improvement have been considered yet, and the transmit signals have been designed to attain such goal, e.g., getting higher SNR or better detector's performance at the receiver. However, an important tool for evaluating the radar's performance is its ambiguity function. In this paper, we consider the problem of transmit signal design, in order to optimize the ambiguity function... 

Two gains play key roles in recently developed MIMO wireless communication systems: "spatial diversity" gain and "spatial multiplexing" gain. The diversity gain refers to the capability to decrease the error rate of the MIMO channel, while the multiplexing gain implicitly refers to the amount of increase in the capacity of the MIMO channel. It has been shown that there is a fundamental tradeoff between these two types of gains, meaning interplay between increasing reliability (via an increase in the diversity gain) and increasing data rate (via an increase in the multiplexing gain). On the other hand, recently, MIMO radars have attracted much attention for their superior ability to enhance... 

It is a well known fact that using multiple antennas at transmit and receive sides improves the detection performance. However, in such multiple-input multiple-output (MIMO) configuration, proper positioning of transmitters and receivers is a big challenge that can have significant influence on the performance of the overall system. In addition, determining the power of each transmitter under a total power constraint is a problem that should be solved in order to enhance the performance and coverage of such a system. In this paper, we design the Neyman-Pearson detector under the Rayleigh scatter model and use it to introduce a criterion for the antenna placement at both transmit and receive... 

There has been much interest, recently, towards exploiting the Multiple-Input Multiple-Output (MIMO) technique in radar. It is shown that using multiple antennas at transmit and receive sides can improve the performance of the system. However, in order to analyze the system's performance, its ambiguity function, i.e. the ambiguity function of a MIMO radar, is needed to be defined. In this paper, beginning from the information theoretic definitions, we derive such function, specifically for a MIMO radar with widely separated antennas  

By combining the two ideas of MIMO (Multiple Input Multiple Output) and PCL (Passive Coherent Location) in radar, one can achieve the advantages of both recently developed techniques simultaneously. While using multiple antennas at the receive side provides a spatial diversity of the object to be detected, using multiple illuminators of opportunity, most importantly, makes the radar covert to the interceptors. One obstacle in such MIMO configuration is choosing the positions of the receive antennas. In this paper, after analyzing the Neyman-Pearson detector for the DVB-T based PCL, we introduce the probability of missed detection as a criterion to place the receive antenna. Here, we only... 

One of the most important obstacles in passive radar applications is removing the direct signal from the target channel. Otherwise, week echoes from the targets in the target channel would be ignored due to the limited dynamic range of the system. One of the most effective techniques in this field is using adaptive filters. In this paper various adaptive filters are introduced and their performances are shown and compared  

It has been shown that using multiple antennas in a radar system improves the performance considerably, since multiple target echoes are received from different aspect angles of the target. In this way, the target detection is improved. However, when using multiple antennas, some problems, such as designing the transmit signals, synchronization, etc. emerge that should be solved. One of such problems is the receiver placement. Receiver placement deals with choosing a proper position for the receive antenna in order to optimize the whole system's performance. In this paper, a receiver placement procedure based on improving the radar ambiguity function is proposed for the case of a multisite... 

By employing the MIMO (multiple-input-multiple-output) technology in radar, some new problems emerged, that, in order to benefit the MIMO gains in radar, it was necessary to solve them suitably. One of such obstacles is determining the positions of receive antennas in a MIMO radar system with widely separated antennas (WS MIMO radar), since it is shown that the antennas' positions affect the whole system's performance considerably. In this study, a proper receivers' positioning procedure is proposed. To do this end, four criteria are developed based on the proposed MIMO detector and the MIMO ambiguity function. The simulations verify that the proposed positioning procedure improves the... 

Phenols and alcohols are silylated with hexamethyldisilazane (HMDS) under microwave irradiation in solvent-free condition in good to excellent yields  

Carbon capture is crucial for mitigating climate change and achieving global emissions reduction targets. Among various technologies, absorption-based methods using aqueous solvents are among the most common and efficient, offering high capture rates and retrofit capabilities for existing industrial facilities. However, selecting the optimal solvent is challenging due to its direct impact on the performance, efficiency, and cost-effectiveness of the carbon capture process. This research introduces a novel multi-class classification methodology for solvent selection in carbon capture. Leveraging a dataset of 656 data points, including features such as temperature, pressure, molar ratio, and... 

Purpose: Intensive actions implemented to alleviate poverty created many challenges. Millions of people face acute food insecurity; hence, food production needs to be increased to feed the existing and increasing population through sustainable agricultural practices. Sustainable agricultural development is the only way forward to assist humanity. Research Method: TExisting literature on sustainable agriculture was reviewed, explored, understood, described, evaluated, and synthesized and their relationships to sustain smallholder farmers were analyzed. Findings: Technological innovations in increasing resource use efficiency, modern breeding techniques, and renewable energy sources aid in... 

Modified couple stress theory is a size-dependent theorem capturing the micro/nanoscale effects influencing the mechanical behaviors of the micro- and nanostructures. In this paper, it is applied to investigate the nonlinear vibration of carbon nanotubes under step DC voltage. The vibration, natural frequencies and dynamic pull-in characteristics of the carbon nanotubes are studied in detail. Moreover, the effects of various boundary conditions and geometries are scrutinized on the dynamic characteristics. The results reveal that application of this theory leads to the higher values of the natural frequencies and dynamic pull-in voltages