Sharif Digital Repository

The present work describes sensing application of modified TiO 2 nanotubes having carbon-Pt nanoparticles for simultaneous detection of dopamine and uric acid. The TiO 2 nanotubes electrode was prepared using anodizing method, followed by electrodeposition of Pt nanoparticles onto the tubes. Carbon was deposited by decomposition of polyethylene glycol in a tube furnace to improve the conductivity. The C-Pt-TiO 2 nanotubes modified electrode was characterized by cyclic voltam-metry and differential pulse voltammetry methods. The modified electrode displayed high sensitivity towards the oxidation of dopamine and uric acid in a phosphate buffer solution (pH 7.00). The electro-oxidation currents... 

In this study a novel Pt/Ni nanostructure consisting of nano-bushes and nanocubes was fabricated onto TiO 2 nanotubes. The scanning electron microscopy images showed that a large amount of well-dispersed nano-architectures had uniformly covered all over the surface which made an electrode with high surface area. It was obviously seen that the nanocube structures mainly consists of Ni had been grown on top of each other while the Pt colonies represented bush-like structures. As a non-enzymatic glucose biosensor, the Pt/Ni TiO 2 nanotubes modified electrode exhibited an excellent performance. The proposed biosensor had two linear ranges for detection of glucose from 0 to 0.12 mM (correlation... 

In this paper, we study three types of jammers, namely, pulse-jammer, partial-band jammer, and follower-jammer, in a typical fiber-optic-based spectrally phase-encoded optical code division multiple-access (SPE-OCDMA) system. We analyze, mathematically, the effects of the aforementioned jammers on the performance of an SPE-OCDMA system for two scenarios, namely, ideal noiseless channel with an ideal optimum receiver and an ultrahigh-speed nonlinear receiver based on two-photon-absorption (TPA) in a noisy channel. Also, for each of the above cases, two types of modulation, namely, on-off keying (OOK) and two-code keying (2CK) are investigated and their system performances are compared. It is... 

Co/Cu multilayers were deposited in a sulfate solution by controlling the current and potential for the deposition of cobalt and copper layer respectively. The electrochemical behavior of these multilayers was studied by cyclic voltammetry and current transients. In addition, a mathematical analysis was used to characterize the electrodeposition system. Simultaneously, the nucleation and growth mechanisms were monitored by these techniques. In this case, the results clearly showed that electrodeposition of cobalt layers was a kinetically controlled process while the reduction of copper ions was a diffusion-control process. Although nucleation mechanism of the single Co deposit was found as a... 

The cobalt-nickel/copper multilayer films were prepared by electrodeposition process in sulfate solution using a three electrode cell. Cyclic voltammetry and double chronoampermetry techniques were utilized to characterize the multilayer system and to obtain the nucleation and growth mechanism. The cyclic voltammograms determined the reduction potential range of the three components and also clearly emphasized that electrodeposition of cobalt-nickel alloy was controlled by a kinetic process, while copper ions were reduced with diffusion-controlled mechanism. These results were confirmed with those which were extracted from the chronoampermetry curves. In addition, the current transients... 

A simple modified TiO2 nanotubes electrode was fabricated by electrodeposition of Pd, Pt and Au nanoparticles. The TiO2 nanotubes electrode was prepared using the anodizing method, followed by modifying Pd nanoparticles onto the tubes surface, offering a uniform conductive surface for electrodeposition of Pt and Au. The performance of the modified electrode was characterized by cyclic voltammetry and differential pulse voltammetry methods. The Au/Pt/Pd/TiO2 NTs modified electrode represented a high sensitivity towards individual detection of dopamine as well as simultaneous detection of dopamine and uric acid using 0.1 M phosphate buffer solution (pH 7.00) as the base solution. In both case,... 

Progressive conversion/shrinking core (PC-SC) models of constant-size cylinders were exploited to interpret the decarburization reactions of MgO-C-Si bricks heated up under blown air. Chemical adsorption/solid (or pore) diffusion mechanisms governed the reaction rate. With 5% silicon, chemical adsorption vanished at 1000 and 1100°C. The oxidation rate lowered then with temperature. This was due apparently to the blocking of the pore-end gorges by the voluminous compounds (like Forstrite). Arrhenius plots of the specific rates yielded the activation energies of the prevailing steps. Without Si antioxidant, three steps were appreciated having activation energies of 51.65 (for chemical... 

TiO2nanocrystals were prepared by hydrolysis and peptisation of titanium isopropoxide under different pH values. The as-prepared powder of very fine anatase crystallites ranges from 8 nm in acidic solution of pH 3 to 10 nm in basic solution of pH 8. Heat treatment of the powders leads to grain growth and anatase - rutile transformation. Experimental results have shown that the anatase to rutile phase transformation in the heat-treated powders depend not only on primary crystallite size but also the presence of brookite phase. It is observed that in the powders with the same size the presence brookite phase would accelerate the anatase to rutile transformation. Furthermore it has been found... 

In this study, the authors perform a complete survey on S-parameter method applications to compensate the coupling effect in circular arrays. The authors illustrate that, despite the simplicity and ease of measurements, the S-parameter algorithm has an adequate performance in comparison with the external calibration techniques in real environments. Based on the simulation and experimental results, for unmatched arrays and low-frequency applications [e.g. high-frequency (HF) radars], the S-parameter method performance is demonstrated to be comparable in accuracy to the external calibration techniques. Despite multipath effect and structural scattering, the direction of arrival can be... 

For direction of arrival (DOA) estimation in compact arrays, a new approach based on time delay and amplitude estimation is presented for a known signal. The DOA can be accurately estimated without any calibration sources since the mutual coupling and multipath effects can be eliminated by the inherent mechanism of the proposed algorithm. The algorithm has significantly lower error and much less computational burden compared with the previous methods in high signal-to-noise ratio (SNR) conditions  

In this paper, we study three types of jammers, namely, pulse-jammer, partial-band jammer, and follower-jammer, in a typical fiber-optic-based spectrally phase-encoded optical code division multiple-access (SPE-OCDMA) system. We analyze, mathematically, the effects of the aforementioned jammers on the performance of an SPE-OCDMA system for two scenarios, namely, ideal noiseless channel with an ideal optimum receiver and an ultrahigh-speed nonlinear receiver based on two-photon-absorption (TPA) in a noisy channel. Also, for each of the above cases, two types of modulation, namely, ON-OFF keying (OOK) and two-code keying (2CK) are investigated and their system performances are compared. It is... 

Landslide events are among natural hazards with many fatalities and financial losses. Studies demonstrate that natural factors such as rainfall and human activities such as deforestation are important causes of triggering a landslide. In this study, an integrated two-dimensional slope stability model, SSHV-2D, is developed that considers various aspects of hydrological effects and vegetation impacts on the stability of slopes. The rainfall infiltration and water uptake of roots change the water content of the unsaturated zone. The temporal and spatial distribution of water content is estimated in the hydrological unit of the developed model. The vegetation unit of the model considers... 

Although, enhanced security is often mentioned as a noticeable benefit of Spectrally Phase Encoded Optical CDMA (SPE-OCDMA) systems, the quantity and degree of security enhancement is not considered deeply in the literature. One of the facts in determining the degree of security is to assess the resistance capability of the system against various jammers attacks. In this paper, we introduce and model three types of jammers, namely (Pulse Jammer, Partialband Jammer, and Follower Jammer). We mathematically analyze the effects of the above jammers on the performance of the SPE-OCDMA systems that use On-Off keying (OOK) modulation scheme. It is demonstrated that under certain conditions, the... 

In this paper, a new software is introduced that is developed to give the most appropriate solution for the component selection and design of a hybrid electric bus. There are several simulation programs that can simulate behavior of a hybrid electric bus, but most of them are not able to suggest the best design and the best choice of the components. Customer requirements are dissimilar and there are several different parameters that they may need. Cost, pollution, driving cycle, battery type, DC link voltage, weight, volume, fuel consumption, and acceleration are some parameters that vary from one customer to the other. The stated software that is developed and presented by this paper will... 

In this paper, sliding-mode control (SMC) is applied to a z-source converter to control output dc voltage of impedance network. The converter is assumed working in continuous conduction mode (CCM). First a comprehensive review of the literature for z-source inverter (ZSI) and use of sliding mode control in switched converters are performed. The procedure of SMC design used in ZSI is presented. The simulations for the application of SMC in z-source inverter are made and the results are illustrated. The results verify the effectiveness and robustness of the controller. © 2008 IEEE