Sharif Digital Repository

This paper studies the optimization of micro turbine application to meet the electrical, heating and cooling loads of a building by energy, economics and environmental analysis. In this study following three cases are considered: 1: A simple micro gas turbine to meet the electrical power of the building. 2: A simple micro gas turbine to meet the electrical power of the building as well as the power required by heat pump and mechanical refrigerator needed for heating, cooling and domestic hot water (DHW) systems. 3: A CHP micro gas turbine to meet the electrical power of the building as well as part of the power required by heat pump and mechanical refrigerator needed for heating, cooling and... 

This research proposes a new method for optimisation of a power generation system based on exergy fuel cost and external social cost of air pollution. A thermodynamic model is provided to estimate the outlet mass flow rates of CO2, CO, NO and NO2 for a gas turbine based on maximising the first and second law efficiencies and minimising the objective function. Results show that inclusion of the external social cost of air pollution increases the optimum excess air ratio if temperature constraint due to metallurgical consideration is disregarded. Otherwise external social cost of air pollution is independent of optimised conditions  

In this paper, a 5 kW PEM fuel cell including burner, steam reformer, and water heater for domestic application has been considered. Water is used for cooling of the fuel cell. Cold water is passed through a cooling channel, warmed up and used for domestic water heating. To increase the efficiency, outlet steam of fuel cell is fed to the reformer. The perfomance of the system is optimized by exergy analysis based on the second law of thermodynamics. Also, the effect of burner, fuel cell temperature and stoichiometric air fuel ratio are investigated. In this analysis, pressure loss in the fuel cell and heat transfer of the cooling channel are taken into account whereas, pressure loss in... 

In the present paper, the effects of inlet fogging system on the first and second law efficiencies are investigated for a typical power plant (Shahid Rajaee) which is located near Ghazvin in Iran. Also a new function is proposed for system optimization that includes the social cost of air pollution for power generating systems. The new function is based on the first law efficiency, energy cost and the external social cost of air pollution for an operational system. Social cost of air pollution is based on the negative effects of air pollution on the health of society and environment. The economic aspect of these effects is called external social cost of air pollution. Other pollution sources... 

Micro gas turbines are considered to meet the electrical, domestic hot water, heating and cooling energy needs of a residential building located in Tehran, Ahvaz and Hamedan. The building is 10 stories high and has a total of 8000 m2 floor area with the peak demands of electricity of 32.96 kW, DHW of 0.926 kW, heating load of 1590 kW and the cooling load of 2028 kW, when the building is located in Tehran. With these demands, 30 micro turbines of 30 kW (nominal power) are needed to meet all the energy needs of the building. The excess electricity generated by the micro turbines is to be used in a heat pump, and the energy in the exhaust gases is to be used to meet other thermal energy needs... 

The Social Cost of nuisance noise from a wind turbine is defined here as the additional cost to reduce the noise level at a receptor to an exceptable, non-nuisance value, i.e. to mitigate this cost. This acceptable sound level is considered to be 35 dB. Our example is a 10-kW (nominal power) wind turbine considered to supply the electrical energy needs of a 3-storey residential building in Tehran and Manjil. The turbine generates sound at 75 dB. To reduce the sound level at the third floor of the building to 35 dB, it was necessary to increase the height of the turbine from 24 m to 48 m. The initial installed cost of the turbine thereby increased from US$45.000 to US$55,000. The cost of... 

For multiple testing problems, Benjamini and Hochberg (1995) proposed the false discovery rate (FDR) as an alternative to the family-wise error rate (FWER). Since then, researchers have provided many proofs to control the FDR under dierent assumptions. Storey et al. (2004) showed that the rejection threshold of a BH step-up procedure is a stopping time with respect to the reverse filtration generated by the pvalues and proposed a new proof based on the martingale theory. Following this work, martingale methods have been widely used to establish FDR control in various settings, but have been primarily applied to reverse filtration only. However, forward filtration can be more amenable for... 

The present article deals with the employment of combined heat and power (CHP) micro gas turbines using natural gas and cold thermal energy storage system (CTES) in Tehran (with mild climate), Bandarabas (with hot and humid climate) and Kerman (with semi-hot climate). A micro CHP produces electricity to meet the electrical energy needs of the building, and it is also considered to meet part of the heating, cooling and domestic hot water energy needs through a heat pump and refrigeration system. A detailed study considering the effect of CTES system on the selection of micro gas turbines of a residential building located in Tehran is performed. The results show that since the number of micro... 

Silver (0) nanoparticles supported on silica-coated ferrite were synthesized to be used as an efficient and recyclable heterogeneous catalyst for oxidant-free dehydrogenation of alcohols to the corresponding carbonyl compounds. The catalyst can be easily recovered and reused for 8 reaction cycles without considerable loss of activity. The facile recovery of the catalyst is carried out by applying an external magnetic device. The catalyst was fully characterized by the techniques of TEM, SEM, XRD, EDS, ICP-AES, and VSM. This journal is  

In this paper, we study theoretically the generation of high repetition rate short pulses using fiber optical parametric amplification. We show that the pulse shape and duration depend on the signal location relatively to the pump frequency. We demonstrate that in order to get the shortest pulse width, the signal must be located at one of the extremities of the gain spectrum associated with the pump peak power. We derive the analytical expression of the pulse shape in this case and compare it to the exponential gain regime case. Using numerical simulations, we also analyze the impact of walk-off and pump phase modulation that is required to suppress Stimulated Brillouin Scattering and derive... 

This paper reports a polarization controllable and angle-insensitive perfect metamaterial absorber (PMA). The proposed PMA consists of periodically arranged asymmetric omega-shaped resonators made of metallic copper. The absorptivity was analyzed considering the microwave C-band from 4 GHz to 8 GHz. The proposed PMA shows an absorption peak with almost 100% absorptivity at 6.2 GHz. Also, wideband negative index of refraction is observed. Further, the absorber is inspected for the different rotation angles of the top metasurface (omega-shaped ring) along the optical axis, and obliquity of incidence angle for both TE and TM polarized waves. Moreover, surface electric field and surface current... 

Recent research efforts were made to investigate botanical bactericides as an intervention tool for citrus canker. Five botanical extracts (Eruca vesicaria, Eucalyptus globulus, Trigonella foenum-graecum, Nigella sativa, and Citrullus colocynthis) were evaluated at three different concentrations (0.25%, 0.5%, and 0.75%) against Xanthomonas citri pv. citri under in vitro conditions. Among all treatments, two effective plant extracts, alone and in combinations, were assessed at three different time points (7 days, 14 days, 21 days) under greenhouse conditions. In vitro and greenhouse experiments were conducted under a Completely Randomized Design. Results showed that C. colocynthis expressed... 

In cloud computing, services play key roles. Services are well defined and autonomous components. Nowadays, the demand of using Fuzzy inference as a service is increasing in the domain of complex and critical systems. In such systems, along with the development of the software, the cost of detecting and fixing software defects increases. Therefore, using formal methods, which provide clear, concise, and mathematical interpretation of the system, is crucial for the design of these Fuzzy systems. To obtain this goal, we introduce the Fuzzy Inference Cloud Service (FICS) and propose a novel discipline for formal modeling of the FICS. The FICS provides the service of Fuzzy inference to the... 

The mixed nano-ferrites materials Cu0.6Zn0.4HoxFe2−xO4 (0.00 ≤ x ≤ 0.12) were prepared via the sol–gel auto combustion technique. The TGA curve established the annealing temperature (500 °C) for phase formation. The single exothermic peak on the DSC plot occurred at 341 °C temperature. XRD patterns of these nano ferrites verified single phase formation of the FCC cubic structure. The lattice constant a was increased from 8.4244 to 8.4419 Å and then its value decreased to 8.4319 Å. Crystallite size was found in the range of 7 to 16 nm. The surface morphology of the samples was observed from the scanning electron microscope (SEM) images. The grain size was found within the range of 90 nm to... 

The mixed nano-ferrites materials Cu0.6Zn0.4HoxFe2−xO4 (0.00 ≤ x ≤ 0.12) were prepared via the sol–gel auto combustion technique. The TGA curve established the annealing temperature (500 °C) for phase formation. The single exothermic peak on the DSC plot occurred at 341 °C temperature. XRD patterns of these nano ferrites verified single phase formation of the FCC cubic structure. The lattice constant a was increased from 8.4244 to 8.4419 Å and then its value decreased to 8.4319 Å. Crystallite size was found in the range of 7 to 16 nm. The surface morphology of the samples was observed from the scanning electron microscope (SEM) images. The grain size was found within the range of 90 nm to... 

In the study presented herein, a simple method for laboratory calcite cementation of a reconstituted gravelly sand was presented. This method was used to prepare cemented gravelly sand specimens, which have similar natural characteristics to alluvial deposit of the city of Tehran. The formation and distribution of calcite bonds, as well as the effectiveness of the presented calcite cementation method in increasing interparticle cohesion, as observed in weakly to moderately cemented soil in Tehran, were evaluated by means of chemical analysis, X-ray diffraction technique, and unconfined compressive strength tests. The cementation technique was used to prepare triaxial specimens with calcite... 

Machine-to-Machine (M2M) communication is an important type of communication in the Internet-of-Things (IoT). How to send data in these high-density communications using relay selection can help improve the performance of this type of communication in various applications. In addition, the possibility of simultaneous use of different Radio Frequency (RF) interfaces helps to use the spectrum more efficiently. In this work, we try to further use machine communication RF equipment and improve the average data rate of networks in some applications such as the IoT, which have their own bandwidth requirements. Therefore, we provide an optimization algorithm for relay selection as well as the... 

The development of new technologies has confronted the entire domain of science and industry with issues of big data's scalability as well as its integration with the purpose of forecasting analytics in its life cycle. In predictive analytics, the forecast of near-future and recent past - or in other words, the now-casting - is the continuous study of real-time events and constantly updated where it considers eventuality. So, it is necessary to consider the highly data-driven technologies and to use new methods of analysis, like machine learning and visualization tools, with the ability of interaction and connection to different data resources with varieties of data regarding the type of big...