Sharif Digital Repository

In this research, an attempt was made toward synthesizing a sol–gel–based silica aerogel and its subsequent coating on a copper wire by phase separation of polystyrene. Adaption of this new approach enabled us to coat the metallic wire with powder materials. The use of this method for coating, led to the formation of a porous and thick structure of silica aerogel. The coated wire was placed in a needle and used as the sorbent for in–tube solid phase microextraction of chlorobenzenes (CBs). The superhydrophobicity of sorbent on extraction efficiency was investigated by using different ratios of tetraethylorthosilicate/methyltrimethoxysilane. The surface coated with the prepared silica aerogel... 

The authors have synthesized a superhydrophobic silica aerogel by using a sol-gel technique. The material is shown to be an efficient sorbent for needle trap microextraction of chlorobenzenes. Hydrophobicity affects the performance of the sorbent as shown by altering the ratio between tetraethylorthosilicate (TEOS) and methyltrimethoxysilane when synthesizing the sorbent. The observed contact angle (which is >150°) underpins the superhydrophobic properties of the aerogel. The microstructure of the sorbent was investigated by BET adsorption, revealing a surface area above 1000 m2 g−1. The sorbent was applied to needle trap extraction of chlorobenzenes from aqueous samples, and their... 

An extracting medium based on chitosan-polypyrrole (CS-PPy) magnetic nanocomposite was synthesized by chemical polymerization of pyrrole at the presence of chitosan magnetic nanoparticles (CS-MNPs) for micro-solid phase extraction. In this work, magnetic nanoparticles, the modified CS-MNPs and different types of CS-PPy magnetic nanocomposites were synthesized. Extraction efficiency of the CS-PPy magnetic nanocomposite was compared with the CS-MNPs and Fe3O4 nanoparticles for the determination of naproxen in aqueous samples, via quantification by spectrofluorimetry. The scanning electron microscopy images obtained from all the prepared nanocomposites revealed that the CS-PPy magnetic... 

Superhydrophobic materials have attracted many attentions in recent years while their application in sample preparation remained almost intact. In this project, a rough surface of melamine formaldehyde foam was silanized by chemical deposition of trichloromethylsilane to form a highly porous and superhydrophobic material, presumably a suitable medium for extracting non–polar compounds such as benzene and its methyl derivatives. The prepared sorbent was packed in a needle for the headspace needle–trap microextraction of benzene, toluene, ethylbenzene and xylenes (BTEX). Major parameters associated with the extraction/desorption processes were considered for optimization. Under the optimized... 

In this research, a new approach for extraction and determination of polycyclic aromatic hydrocarbons from sea and rain water samples was developed by implementing a superhydrophobic substrate and consuming the least amount of solvent. This version of solvent–supported microextraction enabled us to perform the procedure in the immersion mode with the slightest troubles arising from water leakage into the gas chromatography. The superhydrophobic property leads to the fixation of extracting solvent on the substrate surface during water sampling. To prepare a superhydrophobic substrate, a piece of melamine foam was coated by tannic acid and silica nanoparticles using methyltrimethoxysilane and... 

A thin film microextraction method using elecrospun magnetic polybutylene terephthalate nanofibers is developed and implemented to isolate some selected triazines. Due to the high mechanical stability of these nanofibers, they are repeatedly used under harsh magnetic stirring and ultrasonic conditions without any damage and structure degradation. The presence of magnetic nanoparticles within the nanofiber structure increases the extraction efficiency while the fibers could be collected by an external magnet. The synthesized nanocomposite showed strong affinity toward the selected analytes. Apart from the concentration of magnetic nanoparticles within the nanocomposite network, the effect of... 

A superhydrophobic extractive phase was prepared and packed in a needle trap microextraction device for extraction of volatile organic compounds, followed by their determination by gas chromatography. The superhydrophobic phase was prepared by surface modification of melamine formaldehyde (MF) sponge embedded by reduced graphene oxide (rGO). The overall properties of the modified MF along with its high sorption capacity and low cost fabrication were indicative of its feasibility to be highly suitable for extraction of organic pollutants. The determined water contact angle (>150o) from the surface of melamine formaldehyde–reduced graphene oxide (MF–rGO) revealed its high affinity toward... 

This study investigated the effect of anterior cruciate ligament (ACL) injury on relative acceleration of the tibia and femur during a number of tests/activities, in order to assess the feasibility of acceleration-based diagnosis of ACL injury using inertial sensors. First, a detailed finite element model of the knee joint was developed to simulate the target tests/activities, and identify those in which a large difference between the maximum acceleration peaks (MAPs) of the healthy and ACL injured knees is likely to be observed. The promising tests/activities were entered in an experimental study, where the relative accelerations of the tibiae and femurs of 20 individuals with unilateral...