Sharif Digital Repository

Line generators were attractive structures for high-power radio frequency (RF) pulse generation for two decades. Due to some disadvantages, there has been little attention to this type of generator for a relatively long time. In this paper, a nonuniform line generator is used which resolves some of the main shortcomings of conventional line generators. The considered generator can generate RF pulses at higher frequencies with considerably higher repetition rates. Furthermore, the implementation of nonuniform line generators is significantly easier than that of their conventional counterparts. Measurement results for three nonuniform line generators are presented. The possibility of... 

In some well-known passive localization methods, when the number of equations equals the number of unknown object coordinates, there arise finite number of possible solutions. A localization disambiguation technique is required to identify the correct solution in these cases. As an example, the exact solution of time-difference-of-arrival (TDOA) based equations for four receiver sites, leads to a couple of solutions with only one of them being the true target position. This ambiguity, conventionally is resolved by using angle-of-arrival (AOA) measurements or using an additional receiver site which increase the cost and complexity of the system. In this paper a localization disambiguation... 

Passive localisation of non-cooperative targets through their electromagnetic emissions is an attractive issue. This localisation task can be carried out using multitude of receiver sites being linked together. This multiplicity, however, brings about difficulties in organising and coordinating the sites. One can even claim that the method is no longer passive considering the necessary communication links between the sites. On the other hand, single-site localisation methods basically overcome these difficulties eliminating the need for inter-site communications. In this study, a single-site localisation method is presented and analysed. This method is applicable to scenarios with a large... 

In some well-known passive localization methods, when the number of equations equals the number of unknown object coordinates, there arise finite number of possible solutions. A localization disambiguation technique is required to identify the correct solution in these cases. As an example, the exact solution of time-difference-of-arrival (TDOA) based equations for four receiver sites, leads to a couple of solutions with only one of them being the true target position. This ambiguity conventionally is resolved by using angle-of-arrival measurements or using an additional receiver site, which increase the cost and complexity of the system. In this paper, a localization disambiguation... 

Graceful labeling is one of the best known labeling methods of graphs. Despite the large number of papers published on the subject of graph labeling, there are few particular techniques to be used by researchers to gracefully label graphs. In this paper, first a new approach based on the mathematical programming technique is presented to model the graceful labeling problem. Then a “branching method” is developed to solve the problem for special classes of graphs. Computational results show the efficiency of the proposed algorithm for different classes of graphs. One of the interesting results of our model is in the class of trees. The largest tree known to be graceful has at most 27 vertices... 

Graceful labeling is one of the best known labeling methods of graphs. Despite the large number of papers published on the subject of graph labeling, there are few particular techniques to be used by researchers to gracefully label graphs. In this paper, first a new approach based on the mathematical programming technique is presented to model the graceful labeling problem. Then a “branching method” is developed to solve the problem for special classes of graphs. Computational results show the efficiency of the proposed algorithm for different classes of graphs. One of the interesting results of our model is in the class of trees. The largest tree known to be graceful has at most 27 vertices... 

Nerve repositioning surgery is one of the treatments chosen for the patients with edentulous posterior atrophic mandible. Like any other treatments, this therapy has its advantages and disadvantages, indications and contraindications. The most important complication of this procedure is neurosensory disturbance. This problem may occur at different stages of the treatment. One common time when nerve damage happens is when the nerve is located outside the canal and drilling and insertion of the implant are performed. Accordingly, this report describes a simple and feasible method to retract and protect nerves outside the canal during the treatment of nerve transposition. This will reduce the... 

Nerve repositioning surgery is one of the treatments chosen for the patients with edentulous posterior atrophic mandible. Like any other treatments, this therapy has its advantages and disadvantages, indications and contraindications. The most important complication of this procedure is neurosensory disturbance. This problem may occur at different stages of the treatment. One common time when nerve damage happens is when the nerve is located outside the canal and drilling and insertion of the implant are performed. Accordingly, this report describes a simple and feasible method to retract and protect nerves outside the canal during the treatment of nerve transposition. This will reduce the... 

A megawatt-range short pulse generator based on the diode step recovery phenomenon and the Marx generator idea is presented. This generator utilizes both opening and closing switches in one circuit. The proposed circuit is compact, light, and low cost and is driven by a low-power source. By using a three-stage Marx generator, the output peak power of 0.6 MW was obtained. The dimensions of the generator are 8 cm $ imes8$ cm. Experimental measurements of the output pulse characteristics showed a rise time of 100 ns for a 16- $Omega $ load. The input peak power was 4 W which showed more than 105 times increase in the pulse peak power. © 1973-2012 IEEE  

Knowing the rate of evaporation from surface water resources such as channels and reservoirs is essential for precise management of the water balance. Few detailed evaporation studies exist for small lakes or reservoirs in arid regions of the world. In this study, monthly evaporation was determined by Bowen Ratio Energy Budget technique (BREB) for Alghadir reservoir (Saveh, Iran) from 1995-2007 and compared with class-A pan. Daily data were obtained from IMO (Iran Meteorological Organization) weather station, located near the reservoir, for all of these years. Some variations have been observed on the estimated evaporation of the energy budget at different years, ranging from 151 cm for 1997... 

The aim of this paper is to introduce a novel approach, called Endurance Wave Analysis (EWA), for non-linear dynamic analysis and assessment of offshore structures subjected to irregular wave forces. This is, in fact, an extension of the Endurance Time Analysis (ETA) already presented by previous researchers for the seismic assessment of onshore structures. With the EWA method, the offshore structure is simulated under a predefined Intensifying Wave Train Function (IWTF), corresponding to a gradually deteriorating sea state at a specific site. The function is designed so that the roughness of the sea state represented by them increases over the time and even goes well beyond the design sea... 

A high-power short-pulse generator based on the dual action of two coupled diodes, a high-voltage step recovery diode and a high-current diode, is presented. This is made possible using a gas discharge tube. Both analysis and SPICE simulation show about 20-dB peak power increment. This gives a high output power level of 5.7 MW with 1-ns pulsewidth and 450-kHz repetition rate obtained from an input average power of 7.1 kW. An efficiency of about 73% is obtained with more than 30 dB increase in the average power delivered to a 50-Ω load  

In this paper, a novel method for high-repetition-rate high-power radio frequency (RF) pulse generation, which involves only passive solid-state devices and is capable of being used for generating high power microwaves using a low-to-high power converting scheme based on nonlinear self-compression is proposed. The method is also expected to be of low jitter. In the proposed circuit, two high voltage diodes with proper reverse recovery characteristics are used. The simulation results show that the proposed circuit generates RF pulses, with central frequencies up to gigahertz range. By applying a sub-kilowatt power supply, the maximum output power was well over 10 kW. This power can be... 

The nonlinearity of a nonlinear transmission line (NLTL) may have a variety of forms. The Korteweg-de Vries (KdV) equation is the governing equation of a highly specific category of NLTLs having a C - V characteristic as C(V) = C0 (1-bV), but works as an approximate model in a general NLTL having any other kinds of nonlinearities. Here, the soliton response of a varactor-loaded NLTL is studied analytically. The presented analysis gives the exact nonlinear partial differential equation (PDE) governing these networks. It is shown that the obtained PDE, being different from the KdV equation, has soliton solutions showing the well-known properties of the KdV solitons. These obtained solitons... 

The input current of a nonlinear transmission line (NLTL), driven by a step voltage pulse, was analyzed theoretically. As specific results of the analysis, two basic parameters of NLTLs were formulated for the first time: the energy injected to NLTLs and their characteristic impedance. The energy delivered to an NLTL by a square voltage source, with a series resistance of RS, is given by a closed-form formula, which depends on the NLTL parameters and the input pulse characteristics. Considering the importance of the problem of the determining the injected energy content in a wide variety of the different applications of NLTLs, the obtained result will be of great importance, facilitating the... 

A novel high-voltage direct current (HVdc) power supply which has no transformer or voltage multiplier circuit is presented and analyzed in this paper. This is made possible upon the diodes storage delay phenomenon. This proposed power supply is compact, lightweight, and low cost. Its basic structure includes a diode with a proper reverse recovery specification that plays the role of a step-up transformer in the conventional HVdc supplies and a high-voltage capacitor which stabilizes the output voltage. This structure has remarkable advantages over the conventional transformer-based HVdc supplies, such as compactness, a low ripple output, and a low-cost power supply. Performance of the... 

Properly terminating a transmission line, in order to transfer the maximum available power to the load, is an important issue. The problem, fully analyzed in linear lines, is still considered as a persisting problem in the area of nonlinear transmission lines (NLTLs). In this paper, an accurate analysis is presented which gives a closed-form formula for the matching efficiency of the NLTLs. Using this analysis, optimal resistive terminating load for the NLTLs was extracted. These results will considerably ease the design of all kinds of the NLTL-based systems, such as high-frequency oscillators and ultrashort pulse generators. This consistent analysis also gives the reflection coefficient...