Sharif Digital Repository

An expanding flight envelope in the landing phase of a typical jet transport aircraft in presence of strong wind shears using a learning capable control system (LCCS) is investigated. The idea stems fromhuman beings functional architecture that gives them the ability to do more as they age and gain more experience. With the knowledge that classical controllers lack sufficient generality to cope with nonlinear as well as uncertain phenomenon such as turbulent air, the focuse is on different types of intelligent controllers due to their learning and nonlinear generalization capabilities as candidates for the landing flight phase. It is shown that the latter class of controllers could be used... 

In this study a Monte Carlo simulation was used to investigate the effect of cell reactivities and particle diffusivities in the cells and matrix on the diffusion and reaction rate constants in gel-immobilized cell systems with different spatial cell configurations. A variety of conditions were examined ranging from instantaneous to very slow reactions with reaction probabilities equal to or less than one, and diffusivity ratios bigger or smaller than one in a spherical domain. In the case of high reactivity (diffusion-limited), the simulation results indicated a decrease in the reaction rate constants when heterogeneity in the cell distribution was increased. In the case of low reactivity... 

In order to provide anonymity, universal cryptosystems have been used in various applications, including mixnets with multiple receivers. Unlike ordinary re-encryption cryptosystems, universal cryptosystems for re-encryption of ciphertexts do not require knowledge of the public key of the receiver. Golle et al. introduced universal cryptosystems for public key cryptography. Contrary to public key cryptography, in ID-based cryptography, a public key infrastructure is not needed, which makes it suitable for situations where it is not cost-effective to distribute certificates or establish a public key infrastructure. In this paper, we first generalize the definition of universal cryptosystems... 

One of important subjects in power system restoration that already is not addressed is frequency control. Operators are often concerned with the size of load and generation, which can be safely increased. With the emphasis on higher utilization of power systems, monitoring of its dynamics is becoming increasingly important. This requires information with higher accuracy and update rates faster than those usually provided by traditional SCADA systems. In addition, it must be synchronized over a wider geographical area than that provided by traditional protection systems. Nowadays, the introduction of Phasor Measurement Units (PMU) and Wide Area Monitoring Systems (WAMS) as well as advances in... 

The first control action in power system restoration concerns the generation restart. In the initial phase of restoration, operators are often concerned with load pickup problems. One of the important problems during load pickup is keeping frequency response in allowable range. The aim of this paper is to determine the best sequence of load pickup by hydro and steam units during power system restoration based on frequency response of prime movers. Hydro power plants and combustion turbine units have the capability of black start operation and can be used for early stages of power system restoration. This paper considers hydro power plants for evaluating the stability and frequency response... 

In addition to meeting the real-time constraint, power/energy efficiency and high reliability are two vital objectives for real-time embedded systems. Recently, heterogeneous multicore systems have been considered an appropriate solution for achieving joint power/energy efficiency and high reliability. However, power/energy and reliability are two conflict requirements due to the inherent redundancy of fault-tolerance techniques. Also, because of the heterogeneity of the system, the execution of the tasks, especially real-time tasks, in the heterogeneous system is more complicated than the homogeneous system. The proposed method in this paper employs a passive primary/backup technique to... 

In addition to meeting the real-time constraint, power/energy efficiency and high reliability are two vital objectives for real-time embedded systems. Recently, heterogeneous multicore systems have been considered an appropriate solution for achieving joint power/energy efficiency and high reliability. However, power/energy and reliability are two conflict requirements due to the inherent redundancy of fault-tolerance techniques. Also, because of the heterogeneity of the system, the execution of the tasks, especially real-time tasks, in the heterogeneous system is more complicated than the homogeneous system. The proposed method in this article employs a passive primary/backup technique to... 

In this study the effect of deposition temperature and thickness on the physical properties of carbon films deposited by magnetron sputtering PVD was investigated. The results of Raman spectra and grazing incidence XRD (GIXRD) patterns show that the graphitization increases by increasing the deposition temperature. There is a change in deposition mechanism at 400 °C from amorphous carbon deposition to nano-structured graphite deposition. Also by increasing substrate temperature the electrical resistance of carbon films reduces significantly up to 300 °C and then remains largely constant. High intrinsic compressive stress in low temperature deposited carbon films causes cracks and... 

Dynamic Voltage and Frequency Scaling (DVFS) is one of the most popular and exploited techniques to reduce power consumption in multicore embedded systems. However, this technique might lead to a task-reliability degradation because scaling the voltage and frequency increases the fault rate and the worst-case execution time of the tasks. In order to preserve taskreliability at an acceptable level as well as achieving power saving, in this letter, we have proposed an enhanced DVFS method based on reinforcement learning to reduce the power consumption of sporadic tasks at runtime in multicore embedded systems without task-reliability degradation. The reinforcement learner takes decisions based...